2008 L7 Box 4in1 d01.qxp 12/10/2007 12:37 PM Page 3
TSVented
The TS Series vented enclosure combines KICKER’s award winning
The Kicker TS Series enclosure is designed to fit behind the seat of a pickup truck, coupe or wherever space is limited. This design is engineered to provide the best bass response when firing into the back of the seat.
INSTALLATION | Plug your subwoofer speaker wire into the terminals, using the red connector as positive | |
and the black connector as negative. Hook the other end of the wire to your subwoofer | ||
amplifier in accordance with its owner's manual. | ||
Figure 3 | ||
|
Seat
Door Frame
Floor Board
SafetyWarning
To avoid potential injury, or possible death, from forward movement of the enclosure during abrupt stops or accidents, the enclosure must be properly installed and securely fastened to your vehicle. You are solely responsible for securely fastening the enclosure in your vehicle.
4SOLO-BARICSUBWOOFERENCLOSURE
Figure 4
Mount Brackets to the bottom of the enclosure using
the supplied smaller screws. Securely attach the
enclosure to the vehicle with the supplied larger screws.
Performance
Model: | VS10L7 | VS12L7 |
|
| ||
Nominal Impedance [Zn], ohm [per enclosure] | 2 or 4 | 2 or 4 |
| |||
Power Handling* Watts, Peak (RMS) | 1200 (600) | 1500 (750) |
|
| ||
Enclosure Top Surface Depth, in (cm) | 13 | (33.1) | 14 | 11/16 (37.2) |
| PERFOR |
Enclosure Bottom Surface Depth, in (cm) | 16 | 7/16 (41.7) | 18 | (45.7) |
| |
Enclosure Height, in (cm) | 14 | (35.6) | 16 | (40.6) |
| |
Enclosure Width, in (cm) | 17 | (43.3) | 18 | 3/4 (47.5) |
| MANCE |
|
| |||||
Model: | DS12L7 | TS10L7 |
|
| ||
Nominal Impedance [Zn], ohm [per enclosure] | 2 or 4 | 2 or 4 |
| |||
Power Handling* Watts, Peak (RMS) | 3000 (1500) | 1200 (600) |
|
| ||
Enclosure Top Surface Depth, in (cm) | 16 | 3/8 (41.5) | 6 11/16 (16.9) |
|
| |
| ||||||
Enclosure Bottom Surface Depth, in (cm) | 19 | 9/16 (49.7) | 10 (25.4) |
|
| |
Enclosure Height, in (cm) | 16 | (40.6) | 15 (38.1) |
|
| |
Enclosure Width, in (cm) | 32 | 3/8 (82.2) | 21 1/2 (54.6) |
|
| |
Measurements are based on the 4 ohm enclosures. Note: The use of a subsonic filter will significantly increase the power handling.
The power handling specifications in these charts are calculated using a 25Hz, 24dB per octave subsonic filter. *Power Handling Watts RMS without subsonic filter:
5