KFLDS30T
Wide Dispersion, 30W,
Horn Loudspeaker
Installation Instructions
1.Unscrew wing nut and remove threaded pin to separate the mounting base from the horn. Use the base as a template for the mounting holes. Drill three mounting holes and attach the base using appropriate hardware (not included). See Figure 1
IMPORTANT: Make sure the base sits flat on the mounting surface. Tightening the base down on an uneven surface could cause the base to fracture.
The speaker can be mounted to an
2.Reassemble horn on to base after it has been mounted.
3.Remove the plastic cover to make the electrical connections (see Figure 2). Connect the 70V or 25V “hot” lead to the #1 terminal and the system common lead to the #2 terminal. Follow this pattern on all similar speakers to ensure proper phasing; however, the speakers will work perfectly well if the connec- tions are reversed.
4.Adjust the tap selector switch to the desired wattage using the chart below and secure the plastic cover back in place.
TAP | 70V | 25V | IMPORTANT: | |
SET | WATTS WATTS | DO NOT | ||
|
|
| use positions | |
1 | 1.8 | .25 | ||
marked as "*" | ||||
2 | 3.7 | .5 | ||
| ||||
3 | 7.5 | .9 |
| |
4 | 15 | 1.8 |
| |
5 | 30 | 3.7 |
| |
6 | * | 7.5 |
| |
7 | * | 15 |
| |
8 | * | * |
| |
|
|
|
| |
5.Loosen Wing Nut, tilt and swivel the horn to the desired orientation, then
Figure 1
TAP SET
CONTROL
ELECTRICAL
CONNECTION Figure 2
BC1 Beam Clamp
(optional accessory)
©2005 Bogen Communications, Inc. Specifications subject to change without notice.