TROUBLESHOOTING
PROT (Protect) LED Comes On, Amplifier shuts down
Possible Cause
There is a short in the system
Amplifier has exceeded normal operating temperature due to improper ventilation.
Speaker impedance too low
Low battery voltage
Solution
Turn the system off. Check connection to all components for possible shorts. Check all wires and cables for kinks, splices, poor insulation, etc. Repair/replace if necessary.
Turn the system off and allow to cool. Verify adequate ventilation around amplifier. Move the amplifier to a spot with better ventilation if needed.
Check for proper speaker impedance, replace if needed.
Check that the vehicle charging system is maintaining proper voltage.
SPECIFICATIONS
MODEL- R Series | RAA2400 | |
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts | ||
4 | Load Per Channel | 200 Watts x 2Ch and ) 1% THD+N |
2 | Load Per Channel | 400 Watts x 2Ch and ) 1% THD+N |
4 | Load Bridged (Mono) | 800 Watts x 1Ch and ) 1% THD+N |
Dimensions: |
| |
| Height | 2.375" (6cm) |
| Width | 11.5" (29.2cm) |
| Length | 16.75" (42.5cm) |
Amplifier Fuse Rating (Amp/Type) | (3) 30A / ATC | |
Battery Fuse Rating (Amp) External | 90A | |
(Not Supplied) |
| |
>80dB | ||
Crossover | Selectable HPF/LPF or Off (High Pass / Low Pass or All Pass) | |
Crossover Slope | 12dB/octave Butterworth | |
Crossover Frequency (Multiplier X1) | variable from 50Hz to 500Hz | |
Crossover Frequency (Multiplier X10) | variable from 500Hz to 5KHz | |
Frequency Response | 0.25Hz to 100kHz | |
Rated Bandwidth | 20Hz to 20kHz | |
Signal Voltage Adjustment Range (RCA Input) | Variable from 0.15V to 8V | |
Protection | Shorted output, DC offset, | |
|
| thermal, power supply |
Input Impedance | 20k ohms | |
These specifications are Amplifier Power Standard
Specifications subject to change without notice
12