Infinity BU-2 owner manual Method when connecting one subwoofer to satellites

Figure 7. Method when connecting one subwoofer to satellites.

CONNECTING YOUR SUBWOOFER (CONT ’D)

AMPLIFIER

OUTPUTS

RIGHT LEFT

+ – – +

	HIGH LEVEL INPUT
	+ R	–	– L	+
AUTO
POWER POWER
ON OFF
BU-2	+ R	–	– L	+
	HIGH LEVEL OUTPUT
SUBWOOFER
PLATE

+ –

Rear View

R. SATELLITE

LOW LEVEL
INPUT	VOLUME	FREQUENCY
	CONTROL		Hz
L			80˚
	PHASE	60˚	120˚
	-180˚ 0˚		180˚
R
	MIN MAX	50˚	200˚

+ –

Rear View

L. SATELLITE

IMPORTANT!

Figure 8. Method when connecting two subwoofers to satellites.

Depending on whether you are using one or two BU-2 subwoofers, connecting your satellites can be accomplished in one of two ways. If you are using a single BU-2 with a pair of satellites, connect them as shown in Figure 7.

If you are using two BU-2 subwoofers as a stereo pair with a pair of satellites, connect them as shown in Figure 8.

The BU-2 subwoofer does not have a built-in passive crossover which would roll off your satellites’ lower frequencies. However, the BU-2 does have a variable frequency control that can be used to block unwanted frequencies (between 50 – 150Hz) from being reproduced by the subwoofer. Where you set this control depends on the low-frequency capabilities of your satellite speakers. Adjust this knob to the lowest frequency that your satellite speakers were designed to reproduce (refer to Operation, step 8).

AMPLIFIER

OUTPUTS

RIGHT LEFT

+ – – +

HIGH LEVEL OUTPUT
+	R	–	–	L	+
AUTO
POWER POWER
ON OFF
+	R	–	–	L	+
HIGH LEVEL OUTPUT

RIGHT BU-2

SUBWOOFER

PLATE

+ –

Rear View

R. SATELLITE

HIGH LEVEL OUTPUT

+ R – – L +

AUTO

POWER POWER

ON OFF

+ R –– L +

HIGH LEVEL OUTPUT

LEFT BU-2

SUBWOOFER

PLATE

+ –

Rear View

L. SATELLITE

Powered Subwoofer BU-2 – Owner’s Manual ◆ 8