Feature Function | Kramer Electronics VP-200D manual

Figure 3: VP-200D (Lower Side Panel)

#	Feature	Function
1	12V DC	+12V DC connector for powering the unit
2	OUTPUT 2 HD15F Connector	Connect to the computer graphics acceptor 2
3	OUTPUT 1 HD15F Connector	Connect to the computer graphics acceptor 1
4	ON LED	Illuminates when receiving power
5	INPUT HD15F Connector	Connect to the computer graphics source
6	ID BIT Button	Pushing in activates the ID BIT1, releasing deactivates the ID BIT
7	EQ. Control Potentiometer	Adjusts the video EQ. (equalization) compensation
8	LEVEL Control Potentiometer	Adjusts the video signal level

To connect your VP-200DXGA Differential Amplifier / DA, as the example in Figure 4 illustrates, do the following2:

1.Connect a computer graphics source (for example, a computer) to the INPUT HD15F connector.

2.Push in the ID Bit button.

3.Connect the OUTPUT HD15F connectors to up to 2 acceptors, as follows:

Connect the OUTPUT 1 to the acceptor 1 (for example, a projector)

Connect the OUTPUT 2 to the acceptor 2 (for example, a display)

4.Connect the 12V DC power adapter (wall transformer) to the 12V DC socket and connect the transformer to the mains electricity.

5.If required, adjust the video EQ. and/or the video signal level.

It is recommended that you place the VP-200Dat the far end, away from the source, where the differential circuitry would be most effective.

1 Enabling the notebook or laptop to output a VGA signal to an external VGA monitor

2 Switch OFF the power on each device before connecting it to your VP-200D. After powering up your VP-200D, switch on the power on each device