10 TAKING CARE OF YOUR MACHINE
Do not locate your machine in an environment where it is susceptible to dust or moisture. Both of these may damage the electronics, and cause erratic operation or failure. Do not locate your machine where temperature and humidity may be excessive. Doing so may also damage the electronics, and cause erratic operation or failure of your machine. Do not clean your machine with abrasives or strong cleaners. Doing so may remove or damage the finish, or may allow moisture to build up. Take care not to allow dust or particles to build up inside unused or open connectors.
11 TROUBLESHOOTING
NOTES
Please note that if the output signal is disturbed or interrupted by very strong external electromagnetic interference, it should return and stabilize when such interference ends. If not, turn the power switch off and on again to reset the machine.
If the following recommended actions do not result in satisfactory operation, please consult your KRAMER Dealer.
11.1Power and Indicators
Problem |
| Remedy |
|
|
|
No Power | ! | Confirm that power connections are secured at the |
|
| machine and at the receptacle. Make sure the receptacle |
|
| is active, outputting the proper voltage. |
| ! | If there is still no power use a Philips screwdriver to |
|
| remove screws on both sides of the machine and release |
|
| the panel. |
| ! | Locate the fuse inside your machine. Confirm that the |
|
| fuse is good by looking for the wire connected between |
|
| the ends of the fuse. If this wire is broken, replace fuse |
|
| with another, with the same rating. |
| ! | Install cover and tighten the Philips screws. |
KRAMER ELECTRONICS LTD. | 8 |