How to operate the tuner
Button [1]
[FM AM] button | Button [3] |
Changing the reception sensitivity for automatic scanning
The deck lets you select the reception sensitivity to be used for automatic scanning of stations. The two sensitivity modes available for this deck are AUTO mode and DX mode.
| During automatic scanning, the reception sensitivity | |
| switches automatically to one of two levels. Initially the | |
AUTO Mode | reception sensitivity is set to the low level so that only | |
stations with strong signals are received. If no stations | ||
| could be received, the reception sensitivity is increased | |
| so that stations with weaker signals can also be | |
| received. | |
|
| |
| Because the reception sensitivity for automatic scanning | |
DX Mode | is set to the high level from the start, even stations with | |
weaker signals can be received. (Signal crossover may | ||
| ||
| result in some stations being hard to hear.) | |
|
|
1 | Check that the deck is in standby mode. |
2 | Press and hold the button [1], then [FM AM] button, and |
| hold both for more than three seconds. |
The mode switches between AUTO mode and DX mode each time the buttons are pressed.
Changing the radio band location
You can switch the location for the radio bands used between the North American region and the Asia/Australia region. The default setting is USA (North America).
1 | Check that the deck is in standby mode. |
2 | Press and hold the button [3], then [FM AM] button, and |
| hold both for more than three seconds. |
The radio band switches between USA and OTHERS each time the buttons are pressed.
After changing the location, the power will turn on in FM1 mode. After this, the broadcast stations will be searched for automatically and stored in buttons [1] to [6].
43