Sirius™ Connect USB interface board
Installation Instructions
Digital Audio & Analog Audio Out
USB
12 Volts DC
The left connector has analog audio on standard 1/8” (3.5mm) jack. A cable is provided. Also available on this same jack is optical digital audio; an adaptor is provided to allow use of standard Toslink cables.
The center connector is the power supply for the tuner.
Center pin is positive.
The right connector is USB.
When the suspend signal is sent from the computer, the tuner will power off, and draw very little current, this is to prevent battery drain.
Supplied is a coax dc power plug. Use this in a CarPC environment. Again, center pin is the positive. Solder on 2 wires and connect center pin to 12VDC constant (yellow on standard PC power supplies). And the outer is of course ground (black on standard pc supplies).
Page 5 of 13
Created On Tuesday, March 14, 2006