GN |
| Troubleshooting |
| The model | |
E |
|
|
|
|
|
L |
|
|
|
|
|
I |
|
|
|
|
|
S |
| Preliminary Steps |
| ❐ Radio |
|
H |
| Caution: |
| ||
23 |
| Check and take steps as described in the tables | ≥ Do not use the unit if it malfunctions or is | Trouble | Cause/Step |
|
| below. | something wrong. | ||
|
|
|
| ||
|
| If You Suspect Something Wrong | ≥ Do not use the unit in abnormal condition, for |
| Station is too far, or signals are too weak. |
|
| example, without sound, or with smoke or foul |
| ||
|
|
| ➡Select other stations of higher signal level. | ||
|
| Immediately switch the power off. | smell, which can cause ignition or electric |
| |
|
|
|
| ||
|
| Disconnect the power connector and check that | shock. Immediately stop using it and call the |
| The motor antenna relay control lead is not connected correctly. |
|
| there is neither smoke nor heat from the unit before | store where you purchased it. |
| ➡If there is a motor antenna in the car, connect the antenna control |
|
| asking for repairs. Never try to repair the unit your- |
| Too much noise in FM | lead to the motor antenna lead that is installed in the car correctly. |
|
| self because it is dangerous to do so. |
| stereo and monaural | The ground connection of the radio antenna is not secure enough. |
|
| Troubleshooting Tips |
| (AM) broadcasts. | |
|
|
|
| ➡Check the ground connection of the mounted base part of the | |
|
| ❐ Common |
|
| antenna, and tighten up the screw. |
|
|
|
|
| |
|
| Trouble | Cause/Step |
| The radio antenna is not extended enough. |
➡Fully extend the radio antenna.
E
N
G
L
I
S
H
24
No power.
No sound.
Noise.
Audio sound is output but the display shows demonstration message.
Car’s engine switch is not on.
➡Turn your car’s ignition switch to ACC or ON.
Cables are not correctly connected.
➡Connect cables correctly.
➡Connect the battery cable to the terminal that is always active.
➡Connect the accessory cable to your car’s ACC source.
➡Connect the grounding wire to a metal part of the car.
Fuse is burnt out.
➡Call the store where you purchased the unit, or your nearest Servicenter (see the attached sheet) and ask for fuse replacement.
Mute is set to ON.
➡Set it to OFF.
Cables are not correctly connected.
➡Connect cables correctly.
Condensation (dew).
➡Wait for a while before use.
A mobile phone is used near the unit.
➡Keep the mobile phone away from the unit.
The unit’s grounding wire is not connected securely.
➡Check the metal areas of the car body (chassis), and connect the grounding wire more securely.
Demonstration mode is ON.
➡Press [DISP] (display) to cancel demonstration mode.
Preset station is reset. | Battery cable is not correctly connected. | |
➡Connect the battery cable to the terminal that is always active. | ||
|
❐ CD/MP3/WMA |
|
| ||||
CD |
|
|
|
|
|
|
|
| |||||
| Trouble |
| Cause/Step |
Disc is upside down.
➡Place disc in the correct direction with the label side up.
≥Disc is dirty.
≥Disc has scratches.
➡Clean disc, referring to the section on “Notes on CD/CD Media
Disc is in the CD |
|
|
| |
compartment but no | A disc that has data other than | |||
sound is made, or disc | ➡Discs that have | |||
is ejected automatically. |
|
|
|
|
|
|
A disc that has data other than
➡Discs that have CD-DA type data should be used.
➡The unit may not successfully play back a
38 |
| 39 | ||
|
|
| ||
|
|
|
|
|