Pelco C1665M-A (1/06) manual Installation, Mounting

Page 4

Installation

Make sure all parts are present for the unit.

1Terminal block (with tension clamps)

1Wall clip

MOUNTING

The TW3004P transceiver is three rack units high and can be mounted into a fiber rack or onto a wall using a fiber wall mount kit or the supplied wall clip.

USING A RACK

You can mount a TW3004P into either an RK5000PS-3U or an RK5000-3U. For additional information, refer to the RK5000PS-3U/RK5000-3U Fiber Rack Mount Chassis Installation manual.

USING WALL MOUNT KITS

The optional WM5001-3U wall mount base kit allows attachment of a single TW3004P to a wall. Up to two WM5001-3UEXP wall mount expansion kits can be used to allow attachment of two additional transceivers to the wall. For additional information, refer to the Fiber Wall Mount Kits Installation manual.

USING A WALL CLIP

To attach the TW3004P transceiver to a wall using the supplied wall clip, refer to Figure 2 and do the following:

1.Attach the wall clip to a wall using two screws (not supplied).

2.Slide the transceiver into the clip until the two holes on the bottom of the transceiver align with the two holes on the lower flange of the clip.

3.Attach the transceiver to the clip using the two Phillips pan head screws provided with the clip.

4

C1665M-A (1/06)

Image 4
Contents TW3004P Passive Four-Channel Video Transceiver Important Safety Instructions Description Parts of the TransceiverInstallation MountingMounting the TW3004P Using the Wall Clip ApplicationsCable Type Distance Connecting a UTP Camera to a UTP Receiver Coaxitron PTZ Control UTP Camclosure to UTP Receiver Specifications ElectricalProduct Warranty and Return Information ISO9001