FINAL ASSEMBLY
1Locate the factory wiring harness in the dash and make the connection as shown. Metra recomends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent
2
3Reassemble radio and dash assemblies in reverse order of disassembly.
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually tape off ends of any unused wires to prevent electrical short circuit.
A |
|
| |
B | A) | Strip wire ends back 1/2" | |
| B) | Twist ends together | |
C | C) | Solder | |
D) | Tape | ||
| |||
D |
|
|
METRA / EIA WIRING CODE
12V | Ignition / Acc . . . | Red | Right Front (+) | Gray |
12V | Batt / Memory . . | Yellow | Right Front | Gray / Black |
Ground | Black* | Left Front (+) | White | |
Power Antenna | Blue | Left Front | White / Black | |
Amp | Blue / White | Right Rear (+) | Violet | |
Amp Ground | Black / White | Right Rear | Violet / Black | |
Illumination | Orange | Left Rear (+) | Green | |
Dimmer | Orange / White | Left Rear | Green / Black | |
*NOTE: When Black a wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
4