|
|
| Specifications |
|
|
|
|
Specifications |
| ||
|
| Intermodulation Distortion | |
|
| ||
| Power Output Per Channel | ||
| 50 watts into 4 ohm loads and 100 watts into 2 ohm loads | Maximum Intermodulation Distortion if instanta- | |
| is the minimum sine wave continuous average power out- | neous peak output per channel does not exceed | |
| put per channel all four channels operating. | twice the rated output, for any combination of fre- | |
|
|
| quencies from 20Hz to 20,000Hz, with all channels |
| Power Output Bridged | operating is: | |
| 200 watts into 4 ohm loads is the minimum sine wave con- | 0.005% for 4 ohm loads | |
| tinuous average power output. | 0.01% for 2 ohm loads | |
|
|
| 0.01% for Bridged Mode with 4 ohm loads |
| Rated Power Band |
| |
| 20Hz to 20,000Hz | Input Impedance | |
|
|
| 12,000 ohms |
| Total Harmonic Distortion |
| |
Maximum Total Harmonic Distortion at any power level from 250 milliwatts to rated power output is: 0.005% for 4 ohm loads
0.01% for 2 ohm loads
0.01% for Bridged Mode with 4 ohm loads
Dymanic Headroom 1dB
Frequency Response
+0,
Sensitivity
0.5 Volts
105dB (1.5V)
One Band Equalizer
Center Frequency is variable from 40Hz to 2,000Hz, level variable ±12db, Q fixed at 2
Crossover
Selectable High pass or Low pass. The frequency is vari- able from 50Hz to 120Hz. The slope is 12dB per octave (Low pass is 24dB per octave in bridged mode)
Subwoofer Output
Low Pass filtered at 200Hz with a 6db per octave slope (level variable ±12db when using optional McIntosh Exter- nal Subwoofer Rotary Control)
Power Requirements
12 Volts DC, 2.5 amps (idle) - 38 amps (50 watts)
Dimensions
12.5inches (31.8cm) wide, 3.0 inches (7.6cm) high, 13.7 inches (34.8cm) depth
Weight
14.5pounds (6.6Kg) net, 17.0 pounds (7.7Kg) in shipping carton
18