Audiovox SIR-CK2 manual Using Other Manufacturer’s Mounts, Installing the Shuttle into the Cradle

NOTE: Allow a 72-hour period for the adhesive backing to cure completely.

k.Using the star nut, attach the cradle assembly to the base threaded socket; do not overtighten the star nut.

3.Installing the Cradle Using Double-Sided Tape You can mount the cradle directly to your dashboard or other flat surface without using the cradle mount in the kit. To do this, do not remove either of the mounting plate assemblies from the cradle.

a.Remove the 3/4” x 3” double-sided tape from the supplied kit.

b.Determine the location of the cradle, and clean the mounting surface as before.

c.Peel the backing from one side of the tape, and press the tape in place on the rear or bottom cradle mounting plate.

d.Peel the backing from the exposed side of the tape and carefully position the cradle on the mounting surface, gently pressing the cradle into place.

-9-

4.Using Other Manufacturer’s Mounts

The Shuttle Cradle can also be installed using other manufacturer’s mounts; the mounting plate provisions on the rear and bottom of the cradle provide you with multiple mounting options within the vehicle using various vehicle-specific aftermarket brackets, such as those purchased separately from Panavise, Pro-Fit, etc.

5.Installing the Shuttle into the Cradle

The Shuttle cradle has three retaining clips---one on top and two on the bottom. Place the Shuttle in the cradle so that the Shuttle connectors are lined up; use the SAT and TERR RF connectors as guides. Then gently press in on the bottom of the Shuttle to engage the connectors. The top clip will automatically engage; then slide the two bottom clips back into the locked position. Cradle orientation can be adjusted by loosening the star nut and then tightening it when the cradle is in the desired viewing position.

128-6813

9 of 14