Panasonic TH-L32C3M, TH-L32C3K, TH-L32C3T, TH-L32C3X operating instructions Problem Actions

d

s

Screen

Sound

HDMI

Other

Problem Actions

●Change the setting of [P-NR] in the Picture Menu (to remove noise).

Chaotic image, noisy (p. 21)

●Check nearby electrical products (car, motorcycle, fluorescent lamp).

No image can be	●Is [Colour] or [Contrast] in the Picture Menu set to the minimum?
displayed	(p. 21)
Blurry or distorted
image	●Reset channels (p. 28)
(no sound or low
volume)
Unusual image is	●Turn the TV Off with Mains power On / Off switch, then turn it On
displayed	again.
No sound is produced	●Is “Sound Mute” active? (p. 11)
	●Is the volume set to the minimum?
Sound level is low or	●Sound signal reception may be deteriorated.
sound is distorted	●Set [MPX] in the Sound Menu to [Mono] (p. 24)

●Set the sound setting of the connected equipment to “2ch L.PCM”.

Sound is unusual	●Check the [HDMI1 / 2 / 3 Input] setting in the Sound Menu. (p. 24)
	●If digital sound connection has a problem, select analogue sound
	connection. (p. 51)

Pictures from external	●Check that the HDMI cable is connected properly. (p. 41, 47 - 49)
equipment are unusual	●Turn the TV and equipment Off, then turn them On again.
when the equipment is	●Check the input signal from the equipment. (p. 52)
connected via HDMI	●Use an equipment compliant with EIA/CEA-861/861B.
The TV goes into	●Auto power standby function is activated.
	●The TV enters Standby mode about 30 minutes after analogue
Standby mode
	broadcasting ends.
	●Are the batteries installed correctly? (p. 8)
The remote control	●Has the TV been switched On?
	●Point the remote control directly at the front of the TV
does not work or is
	(within about 7 m and a 30 degree angle from the front of the TV).
intermittent
	●Place the TV away from sunshine and do not let other sources of
	bright light to shine on the TV’s remote control signal receiver.

Frequently Asked Questions

57

TH_L32C3KMTX_EN.indd 57

3/17/2011 3:46:11 PM