Low Level Input Wiring
Low-level (RCA) input wiring is preferred for best audio performance. Always use a high-quality RCA cable for best audio performance.
NOTE: Do not connect BOTH the high level and low level inputs from your receiver to your amplifier at the same time!
MonoBlock Amplifier
CX1100M
Remote Subwoofer
Level Control
| | | | | | | | LOW PASS | | | | | | | | |
POWER | | | | | | | FREQUENCY | MODE | | LEVEL | SENSITIVITY |
| | | | | 100 | 145 | | | | | | | |
| | | | | | 40 | 155 | | | | | | | |
| | | | | | | | | | | | |
| | | | | 0 +18dB | | | | | | | | | 2-8V 100mV-2V |
| | | | | 35 Hz 160 | | FULL RANGE | MIN MAX |
REMOTE SUBWOOFER | | BASS BOOST | | CROSSOVER | | | INPUT CONTROLS | |
LEVEL CONTROL | | | | | | | | | | | | | | | | |
| | | | | | | | | | | | | | | | | | |
M O S F E T M O N O B L O C K P O W E R A M P L I |
To Audio Outputs of head unit or
signal processor
MonoBlock Amplifier
CX2000M
Remote Subwoofer
Level Control
| | | | | | | LEFT | | | | RIGHT |
POWER | | | | | | | | | | | | | | | |
| | | | | | | | | | | | | | | | |
| | | | | | | | | | | | | | | | |
| + L | | R + | | | | | | | | | |
| | | | | | | | | | |
| | HIGH LEVEL | | | | | | | | | | |
| | | | | I | | | | | | | | | | |
| | | | | | | | | | | | | | | | |
INPUT BASS CROSSOVER
LEVEL BOOST FREQUENCY
PROTECTION
REMOTE SUBWOOFER
LEVEL CONTROL
O S F E M O N O B L O C K P O W E R A M P L I F I E R |
To Audio Outputs of head unit or
signal processor
CHAOS EXXTREME MOSFET Amplifier User’s Manual - page 8
CX2000M
E R ’ S M a N U a L
What is included?
Introduction
Features
About 2 Ohm operation
General precautions
Installation precautions
Mounting the amplifier
Shock HAZARD! Do not open the case
Connecting the amplifier
Dont misuse the level control
Low Level Input Wiring
Channel Amplifiers
CX250, CX450, CX550 CX750, CX950, and CX1250
CX600, CX650, CX800, and CX1000
Channel Amplifier
CX1800
CX2000M
MonoBlock Amplifier
CX1100M
High Level Input Wiring
CX250, CX450, CX550, CX750, CX950, and CX1250
To Speaker
Terminals
To Speaker Terminals Head unit
To Speaker Terminals
Head unit
Power and Speaker Wiring
Bridged Mode
Two
Channel
Tri-Mode
Tri-Mode
Four Channel Mode
CX600, CX650, CX800 and CX1000
Component values for
6dB Passive Crossover
Five Channel Mode
Speaker Impedance
Bridged Mode
Tri-Mode
MonoBlock Mode
CX1100M and CX2000M
Troubleshooting
Symptom Possible Remedy
CX600 CX650 CX800 CX1000 CX1800 CX1100M CX2000M
Specifications
CX250 CX450 CX550 CX750 CX950 CX1250
Page
PROTECTION