Boss Audio Systems BASS1000 user manual Low Level Input Wiring, High Level Input Wiring

Low Level Input Wiring

Low-level (RCA) input wiring is preferred for best audio performance. Most trunk or hatchback installations will require a 15-20 foot RCA cable, while pickup trucks and under-seat installations will require a 6-12 foot RCA cable. Always use a high- quality cable.

NOTE: Do not connect BOTH the high level and low level inputs from your receiver to your amplifier at the same time!

POWER	PHASE		LOW PASS		BASS	INPUT
CONNECTIONS	SHIFT		FILTER		BOOST	GAIN
GROUND
	0	180º	50Hz	150Hz	0 +12dB	MIN MAX
REMOTE
+12V				AMP LIFIED SUBWOOFER
		REMOTE		INPUTS
					LINE
POWER STATUS		LEVEL
					LEVEL
GREEN = ON		CONTROL
				HIGH LEVEL
RED = PROTECTION
FUSE
						To Audio
						Outputs of head
						unit or signal
						processor

High Level Input Wiring

The high level input(s) should only be used when your receiver lacks RCA outputs. If the RCA outputs are not present, connect the speaker outputs from the receiver to the high level input connector of the amplifier. Be sure to observe polarity to avoid audio phase problems.

NOTE: Do not connect BOTH the high level and low level inputs from your receiver to your amplifier at the same time!

GROUND

REMOTE

+12V

FUSE

POWER	PHASE		LOW PASS	BASS	INPUT
CONNECTIONS	SHIFT		FILTER	BOOST	GAIN
	0	180º	50Hz 150Hz	0 +12dB	MIN MAX
			AMP LIFIED SUBWOOFER
		REMOTE	INP	S	L
				LINE
POWER STATUS		LEVEL
		CONTROL		LEVEL
GREEN = ON			HIGH LEVEL
RED = PROTECTION

R

WHITE L+		R+ GREY
WHITE/BLACK L-	R- GREY/BLACK

To Speaker Terminals of head unit

BASS1000 Amplified Subwoofer User’s Manual - page 8