Maintaining the cassette deck
Troubleshooting guide
Performing routine maintenance helps keep your cassette deck operating at peak performance.
Cleaning the heads
We recommend that you clean the head assemblies, tape guides, capstans, and pinch rollers of both cassette wells after every 10 hours of use. For best results, use tape head cleaning fluid and
1Open the cassette well doors.
2Dip a swab into the cleaning fluid, and clean the surface of the heads.
Heads | Capstan shaft |
Pinch roller
3Using a clean swab, clean the capstan shafts, making sure to clean all the way around them.
4Using a clean swab, clean the pinch rollers, making sure to clean all the way around them. Use a clean swab to keep them from turning.
Demagnetizing the heads
Since tape is magnetic, when the tape heads and capstan shaft contact the tapes, they become magnetized over time, increasing distortion. Playing tapes on a player with magnetized heads and capstans can also deteriorate the recordings on the tapes. For best performance, use a head demagnetizer to demagnetize the heads and capstans of both cassette wells.
Sometimes things just don’t seem to be working right.
When this happens:
•First, look back over this manual to find the instruc- tions for what you’re trying to do. You may find the solution to your problem right there.
•If that doesn’t work, look for the problem in this Troubleshooter’s guide.
•If you have a problem with another component, check the manual for that unit.
•If you still can’t solve the problem, call the store where your purchased your system, or call a Kenwood Authorized Service Center.
To find a Kenwood Authorized Service Center
•Call
Receiver
Remote doesn’t operate
•Check the batteries, and replace them if needed.
•Check that the remote is close enough to the system; that the controlling angle is small enough; that there’s no obstacle in between.
•Check that you’ve placed your CD, videotape, laser disc, or other source in the proper player.
•Check to make sure that the audio cables and system control cables are connected properly.
No sound from the system
•Check that the volume is set at a proper level.
•Check that the mute is OFF.
•Check that the speakers are turned ON. If the speak- ers are ON, the speaker indicator is ON.
•Check that all your power cords are connected prop- erly.
•Check that the speaker cables are connected prop- erly.
•Check that the input cable from the source compo- nent is connected properly.
•Check that the shorting plugs have not been removed from the ADAPTER loop jacks.
No sound from one of the speakers
•Check that the balance between the left and right speakers isn’t set too far to one side.
•Check that the audio and speaker cables are connected properly.
The STANDBY light blinks, but there is no
sound
•Check that the speaker cables aren’t
A hum when you select the PHONO input
•Check that the audio cables are plugged securely into the PHONO jacks.
•Check that the turntable is grounded on the rear panel. The ground wire should be connected to the screw labeled GND.
None of the functions operate, or the display
shows wrong information
•
36. | 37. |