Page 4 of 8 | SA-365-10 Installation Instructions |
OPTION SWITCHES
An 8-position DIP switch on the remote amplifier may be changed to select various options.
Option Switches
Default Setting Shown (Switches OFF)
SW-1 Auxiliary Input Polarity - The auxiliary input is normally activated with positive, turn this switch ON for negative activation.
SW-2 | SW-3 | Auxiliary Input Function |
| | with Unit set to Standby |
OFF | OFF | (Default) Produces Horn tone while activated. |
ON | OFF | Produces Phaser tone while activated. |
OFF | ON | Produces Manual siren tone. |
ON | ON | Activates Horn Ring Cycler 2 (HRC2) function. |
SW-4Two-Tone- Turn this switch ON to replace Phaser with Two-Tone.
SW-5 Phaser Inhibit - Turn this switch ON to disable Phaser tone. Phaser replaced with Yelp.
SW-4 and 5 Siren Tone Disable - All siren tones may be disabled except Horn by turning ON both switches. All switches will produce Horn tone.
SW-6 Horn Inhibit - Turn this switch ON to disable Horn tone. Horn replaced with Yelp.
SW-7 Short Manual - The manual tone normally falls and dies out when the manual switch is released. Turn this switch ON to have the tone stop immediately.
SW-8 Phaser Override - While in standby mode, the manual switch will normally activate manual tone. Turn this switch ON to momentarily activate Phaser tone.
HORN RING CYCLER 2 (HRC2) - Turn on DIP SW-2 and SW-3 to enable this feature. Also connect the auxiliary input to the horn ring or other switch. While the siren is in standby, tap the horn ring to bring the unit out of standby into Wail tone. Repeatedly tapping the horn ring will cycle through Wail, Yelp, and Phaser tones. Tapping the horn ring twice quickly will stop the siren tones and return the unit to standby. Pressing and holding the horn ring will produce Horn tone until released. Then the siren will return to its previous siren tone or standby.