Installation
MOUNTING:
1.After reading precaution, decide where you are going to install the unit. Also, see Fig.1.
2.Once the location has been determined, place the amplifier in position. Using a felt tip pen or pencil mark the four holes to be drilled for mounting. NEVER use the amplifier as a template for drilling.
It is very easy to damage the amplifier surface in manner.
3.Remove amplifier. Drill four 3.5 m/m. Diameter holes into mounting surface on steel panel.
If you want mounting the MDF or wood panel, drill four 3.0m/m diameter holes into mounting surface.
4.If possible, test the system operating before final mounting of the amplifier.
5.Mount the amplifier using the supplied 4 self threading screws.
Installation Diagram
SELF TAP SCREWS 
Fig1.
3