Harman HK 990 owner manual Independent Remote Control, Operating Conditions

HK 990

Remote Control

Independent Remote Control

The system remote of the HK 990 can control the amplifier, compatible tuners, CD players and CD recorders. The Remote In jack of units without an integrated IR receiver must be connected to the amplifier’s Remote Control Output jack so that the system remote control can operate them.

Important notes:

•• To remote-control a tuner, CD recorder or CD player, the appropriate input (“TUNER,” “CDR” or “CD”) must have been selected with the source buttons of the remote control (selecting on the front panel is not sufficient).

•• Note that DVD players cannot be controlled by the remote.

Operating Conditions

The control unit operates effectively within a distance­ of 23 feet (7 meters) and an angle of 30° from the amplifier. Using the control near fluorescent lights may shorten this range, as will any dust or dirt that accumulates on the front of the remote control or

the remote-sensor area of the amplifier­ . Also, avoid blocking the line of sight between amplifier and remote.

Install the four supplied AAA batteries in the remote as shown. Be certain to follow the (+) and (–) polarity indicators that are on the top of the battery compartment.

When you replace weak batteries, replace all at the same time. When the remote is to be unused for an ­extended period, remove the batteries to prevent damage from corrosion.

Instructions for Users on Removal and Disposal of Used Batteries. Specification of Included Battery Types.

These symbols shown on the product, the packaging or in

the manual or separate information sheet mean that the product itself, as well as the batteries included or built into the product, should never be thrown away with general household waste. Take them to applicable collection points, where proper treatment, recycling and recovery takes place, in accordance with national or local legislation, or European Directives 2002/96/EC and 2006/66/EC.

Correct handling of the product and batteries to be disposed helps save resources and prevents possible negative effects on the environment or human health.

The batteries included with your equipment may be alkaline, carbon zinc/manganese or lithium (button cells) type. All types should be disposed of according to the above instructions.

To remove the batteries from your equipment or remote control, reverse the procedure described in the Owner’s Manual for inserting batteries.

For products with a built-in battery that lasts for the lifetime of the product, removal may not be possible for the user. In this case, recycling or recovery centers handle the dismantling of the product and the removal of the battery. If, for any reason, it becomes necessary to replace such a battery, this procedure must be performed by authorized service centers.

Device On/Off	System Off
	Button
Buttons
System On
Buttons
Mode Button	Time Button
	Display Button
Info/RDS Button
Band Button	Numeric
	Buttons
FM Mode Button	(0–9)
Auto Button
Mem Button	Prog Button
Clear Button	Check Button
Speaker Setup	Input Setup
Button	Button
	Arrow
	Buttons
EQ Preset	Level Settings
Button	Button
	Enter Button
Scroll +/–	Volume +/–
Buttons	Buttons
	Pause Button
Select Button	Mute Button
<< Button	>> Button
Stop Button	Play Button
<< Button	>> Button
	Repeat Button
+10/–10	Open/Close
Buttons
	Button
Folder +/–
	Random
Buttons
	Button
Repeat A/B
Button

8