EON510 Specifications
System Type: | Self powered 10", | |||||
Frequency Range | 58 Hz - 18.5 kHz (EQ in ‘Flat’ position) | |||||
Frequency Response (±3 dB): | 70 Hz - 17 kHz (EQ in ‘Flat’ position) | |||||
Coverage Pattern: | 100º x 60º nominal | |||||
Directivity Index (DI): | 9 dB | |||||
Directivity Factor (Q): | 8 |
|
|
|
| |
Crossover Frequency: | 1.6 kHz | |||||
System Power Rating | 280 W continuous, 560 W peak | |||||
LF Power amp | 220 W continuous at driver impedance | |||||
HF Power amp | 60 W continuous at driver impedance | |||||
Distortion: | Less than 0.1% at rated power | |||||
Maximum SPL: | 121 dB | |||||
| Limit: Red LED indicates input overload condition | |||||
Signal indicators: | Signal: Green LED indicates signal present | |||||
| Mic/Line: Red LED indicator | |||||
Input Gain (input 3): | Mic position: | |||||
Line position: | ||||||
| ||||||
Input Gain (input 1 & 2): | ||||||
Input Impedance: | 64 K Ohms (balanced), 32 K Ohms (unbalanced) | |||||
Boost EQ: | LF +3 dB Shelving Filter @ 150 | |||||
HF +2.5 dB Shelving Filter @ 4 kHz | ||||||
| ||||||
Low Cut Filter | Preset high pass @ 120 Hz | |||||
LF Driver: | 1 x JBL 261F 254 mm (10 in) Differential Drive® integrated woofer with dual 1.5” voice coils. | |||||
HF Driver: | 1 x JBL | |||||
Input 3 connector: | Balanced XLR / ¼ inch TRS combo jack with XLR loop through | |||||
Input 1 & 2 connectors: | Balanced ¼ inch TRS jack | |||||
Output (Loop/Mix switch): | Balanced male XLR, +20 dBu (peak) o/p level in MIX position | |||||
XLR Pin Assignments: | Pin 2(+), Pin | |||||
Limiting/Protection: | Dynamic Limiter | |||||
Enclosure: | PP impact copolymer, | |||||
Handles: | One on top with rubber grip | |||||
Suspension/Mounting: | 36 mm pole socket with stabilizing screw, 3 x M10 suspension points, 1 x M10 | |||||
Grille: | Powder coated perforated steel with acoustically transparent black screen backing. | |||||
AC input: | ||||||
Dimensions (H x W x D): | 490 x 315 x 262 mm (19.3 in x 12.3 in x 10.3 in) | |||||
Net Weight: | 7.7 kg (17 lb) | |||||
Block Diagram | LOOP |
|
|
|
| |
|
|
| ||||
MIX |
|
|
|
| ||
|
|
|
|
| ||
| OUT |
INPUT 3
LEVEL 3
LINE
MIC
MIC
LIMIT
SUM
EQ
BOOST
FLAT
CUT
HPF
LPF
HF
LF
INPUT 1 & 2 | SUM | SIGNAL |
|
|
LEVEL 1 & 2
11