OPERATION
1
2
3
4
5
6
7
|
|
|
| MASTER | SLAVE |
L |
|
|
|
|
|
| 6V 0.2V | 50Hz 250Hz 0dB 12dB |
|
| |
R | GAIN | L.P.F | BASS | REMOCON | SLAVE |
|
| BOOST |
|
| |
|
|
|
|
| |
LINE INPUT
1. | RCA Input Jacks | 2. Input Level Control | 3. | Low Pass Frequency |
4. | Bass Boost |
|
|
|
5. | Remote Control Jack | 6. Master/Slave Switch | 7. | Slave Input Jack |
Control and Crossover
1.RCA Input Jacks - Low
2.Input Level Control - Adjust the input level for the marked channels. Turn clockwise to increase the level, counterclockwise to decrease. Amplifiers will run cooler and produce less system noise at lower level settings.
3.Low Pass Frequency - Adjust the crossover frequency by turning clockwise to set to a higher frequency, counterclockwise to set to a lower frequency.
4.Bass Boost - Adjust the sub boost level of the selected frequency output from 0dB to 12dB.
5.Remote Control Jack - For connecting the remote control module to the amplifier.
6.Master/Slave Switch - Select the remote level control or the
7.Slave Input Jack - Used to connect to another amplifier when bridging 2 amps together. The Slave mode bypasses normal input jacks and controls.
8