Setup Procedure
English
1. Determine the installation location
CAUTION: DO NOT ATTEMPT TO INSTALL THE LCD MONITOR BY YOURSELF.
Installing your LCD display must be done by a qualified technician. Contact your dealer for more information.
CAUTION: MOVING OR INSTALLING THE LCD MONITOR MUST BE DONE BY TWO OR MORE PEOPLE.
Failure to follow this caution may result in injury if the LCD monitor falls.
CAUTION: Do not mount or operate the display upside down, face up, or face down.
CAUTION: This LCD has a temperature sensor and cooling fan. If the LCD becomes too hot, the cooling fan will turn on automatically. If the LCD becomes overheated and the cooling fan is running, the “Caution” menu will appear. If the “Caution” menu appears, discontinue use and allow the unit to cool. When the LCD monitor is used in an enclosure or with protection on LCD surface, please check the inside temperature of monitor by “HEAT STATUS” (See page 26). The temperature is too hot than normal condition, please set “cooling fan” to ON on SCREEN SAVER function (See page 23).
IMPORTANT: Lay the protective sheet, which was wrapped around the LCD monitor when it was packaged, beneath the LCD monitor so as not to scratch the panel.
2. Install the remote control batteries
The remote control is powered by 1.5V AA batteries. To install or replace batteries:
1.Press and slide to open the cover.
2.Align the batteries according to the (+) and
3.Replace the cover.
CAUTION: Incorrect use of batteries can result in leaks or bursting.
Be careful especially about the following points.
•Place “AA” size batteries matching the + and - signs on each battery to the + and - signs of the battery compartment.
•Don’t mix battery types.
•Don’t combine new batteries with used ones.
It causes shorter battery life or leakage of batteries.
•Remove dead batteries immediately to prevent battery liquid from leaking into the battery compartment.
Don’t touch exposed battery acid, it cause damage to your skin.
NOTE: If you do not intend to use the Remote Control for a long period, remove the batteries.
3. Connect external equipment (See pages
•To protect the connected equipment, turn off the main power before making connections.
•Refer to your equipment user manual.
4. Connect the supplied power cord
•The power outlet socket should be installed as near to the equipment as possible, and should be easily accessible.
•Fully insert the prongs into the power outlet socket. Loose connection may cause noise.
•Please fix the power cord by attaching the screw and clamper.
NOTE: Please refer to “Safety Precautions, Maintenance & Recommended Use” section of this manual for proper selection of AC power cord.
Screw Clamper
Screw hole for clamper
5.Switch on the power of all attached external equipment
When connected with a computer, switch on the power of the computer first.
6. Operate the attached external equipment
Display the signal on the external equipment you wish.
7. Adjust the sound
Make adjustments when adjustment of the volume is required.
8. Adjust the screen (See pages
Make adjustments when adjustment of the screen display position or distortion is required.
9. Adjust the image (See pages 19-26)
Make adjustments when picture adjustment such as the brightness or contrast is required.
Downloaded From