Connect the wires as indicated | Farenheit Technologies HRD-9BK

Connection Diagram

How To Control The Monitor

Connect the wires as indicated:

a.Red: Connect to a switched(+) 12 volt source (ACC). Use a lead that has(+) 12V

when the ignition on or in the ACC position so the monitors turns off when the key is in the off position. Wiring the monitors hot could cause your battery to run down when the engine is not running.

b.Black: Connect to a good chassis ground.

c.Reversing the polarity of the red and black leads will damage the monitor.

d.Connect the video input connector to the video output from the source unit

(i.e. DVD player) e. Test the syetem.

3. Picture Control Menu

CONTRAST

BRIGHTNESS

COLOR

RESET

MENU MODE

USB

AV2

Note

If there is no more touch control for 5 seconds while any buttons or the Picture Control Menu are being shown on the monitor, all buttons & menu will be disappeared automatically.

(1)When the MENU button on the monitor screen is pressed, the picture setting menu will be shown.

(2)Use to achieve the desired settings for

CONTRAST,BRIGHTNESS, COLOR, FM and RESET.

CONTRAST	: Contrast between light and shade
BRIGHTNESS : Dim		Bright
COLOR	: Control of color
SHARPNESS : Sharpness of view
FM	: 87.7	89.1MHz
RESET	: Brings its factory defaults

(3)Press the MENU button continuously to highlight the desired picture setting menu to control, and adjust the values with the left /right arrow buttons while menu OSD is still displayed on the screen for changing the values.