TROUBLE SHOOTING
Before using this checklist, please make all the connections first. If you still have questions after going through the checklist, please consult your local customer service representative.
Common Symptoms | Cause |
There is no power. | The car ignition is switched off. |
| |
| The fuse has blown. |
The CDs cannot | Presence of CD inside the player. |
be loaded. |
|
Solution
If the power supply is properly connected to the car accessory, switch the ignition key to “ON” or “ACC”.
Replace with another fuse according to the wiring diagram.
Remove the disc in the player, then put in a new one.
The CDs are loaded only halfway into the CD tray.
The device does not work correctly.
(EJECT, LOAD, PLAY)
There is no sound.
The transport screws have not been removed.
The disc has been inserted upside down.
The surface of the CD is extremely dirty or damaged.
Temperature inside the car is too high.
The volume control is set too low.
The device has not been correctly connected.
Remove the transport screws before use.
Insert the compact disc with the label facing upward.
Clean the CD or try another CD. If this works correctly, the first CD is probably damaged.
Cool off until the ambient temperature returns to normal.
Turn up the volume to an audible level.
Check the power and earth connection according to the wiring diagram.
The operation keys | 1. The |
do not work. | operating properly due to noise. |
| 2. The front panel is not properly |
| in place. |
| The installation angle is more than |
| 30 degrees. |
The CD player | The surface of the road is uneven. |
skips. |
|
| The surface of the CD is extremely |
| dirty or damaged. |
1.Switch the device off and on again. Or, press the RESET button to resume the program.
2.Reinstall the front panel. Adjust the installation angle to less than 30 degrees.
Wait until the road becomes smoother before playing the CD.
Clean the CD or try another CD. If this works correctly, the first CD is probably damaged.
No radio reception.
In automatic search Mode, the radio does not stop at a trans- mitting station.
The antenna cable is not connected.
The transmission signals are too weak.
Insert the antenna cable firmly into the antenna socket of the device.
Tune in to a radio station manually.
Page 8