Pioneer DEX-P9 owner manual Installation, DIN Front/Rear-mount, DIN Front-mount

Installation

Note:

•Before finally installing the unit, connect the wiring temporarily, making sure it is all connected up properly, and the unit and the system work properly.

•Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.

•Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.

•Install the unit where it does not get in the driver’s way and cannot injure the passenger if there is a sudden stop, like an emergency stop.

•The semiconductor laser will be damaged if it overheats, so don’t install the unit anywhere hot

— for instance, near a heater outlet.

•If installation angle exceeds 60° from horizontal, the unit might not give its optimum performance. (Fig. 6)

60°

Fig. 6

DIN Front/Rear-mount

This unit can be properly installed either from “Front” (conventional DIN Front-mount) or “Rear” (DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). For details, refer to the following illustrated installation methods.

DIN Front-mount

Installation with the rubber bush (Fig. 7)

Dashboard

182

53

Holder

After inserting the holder into the dash- board, then select the appropriate tabs according to the thickness of the dash- board material and bend them.

(Install as firmly as possible using the top and bottom tabs. To secure, bend the tabs 90 degrees.)

Rubber bush

Screw

Fig. 7

75