Hyundai H-CDM8010 instruction manual Beep function, Clock setting, DSP mode, Preset volume level

Page 13

BEEP function

Press and hold SEL knob for 2 seconds; the display will show “TA SEEK”. Press SEL knob repeatedly until the display shows “BEEP OFF”, rotate SEL knob to toggle between BEEP ON and BEEP OFF, then leave the unit idle for your desired setting to take effect.

Clock setting

The clock can be set anytime when the power is on. Press CLK button and then press and hold CLK button for 3 seconds, the time will blink on the display.

1.Rotate SEL knob clockwise to adjust the hour.

2.Rotate SEL knob anti-clockwise to adjust the minute.

3.Press CLK button again or leave the unit idle for new setting to take effect. Press CLK button anytime to view the time display.

DSP mode

Press and hold SEL knob for 2 seconds, the display will show “TA SEEK”. Press SEL knob repeatedly until the display shows “DSP OFF”. Rotate SEL knob to select DSP effect.

POP ROCK CLASSIC FLAT DSP OFF

After you have selected your desired effect, leave the unit idle in order for the new setting to take effect.

Preset volume level

Press and hold SEL knob till the display shows “TA SEEK”. Then press SEL knob repeatedly till “VOL LAST” is displayed. In this mode the unit will be turned on with the same volume level at which the unit was shut down last time.

13

Image 13

Contents CDM8010 Table of contents Important safeguards Accessories Before installation Installation/ConnectionsMark polarity of the speaker wires Remove the old unit from the dashboardPage Installation method a Installation method B Electrical connections Speaker Wiring NotesUsing the ISO Connector Front panel Panel controlsGeneral operations DSP mode Clock settingPreset volume level Beep functionRCA output Choose Radio Band Radio operationsRadio Tune/Seek Function Auto seek modesAutomatic Store/Preset Scan Save Your Preset StationsLocal/Distance reception control RDS-EON Control RDS operationsAF Alternative frequency TA Traffic announcementMask DPI/MASK ALL PTY Program typeElectronic Shock Protection ESP CD/MP3/WMA operationsInsert/Eject discs For MP3 discsMulti-session CD reading MP3 Track search modePlay/Pause disc Selecting tracks/Fast Forward/RewindScanning tracks RepeatMP3 Overview Page Cleaning the cabinet CleaningCleaning discs Handling discsPage Symptom Cause Solution Troubleshooting guidePage General SpecificationFM stereo radio MW sectionLine out Audio specificationУвааемый пοкупатель СοдераниеΜеры предοстοрοнοсти Page Кοмплект пοставки Устанοвка/Пοдключение Page Βнимание Примечание Примечания Ηοмер Функция ISOЭлементы управления Loud Οснοвные οперацииDSP BeepRCA «SEEK 2» Οперации с радиοPage RDS-EON Функция RDSRetune S/L PTYESP Οперации с дисками СD/MP3/WMAДля MP3 дискοв Для CD дискοвПрοстοй пοиск MP3Пοиск трека Пοиск файлаPREV/NEXT ID3 Οбзοр ΜΡ3 CD-R CD-RW Οбращение с дисками Чистка и ухοд Page Ηеисправнοсть Причина Ρешение Ρукοвοдствο пο устранению неисправнοстейPage Οбщие Τехнические характеристикиFM радиο MW радиοΑудиο Линейный выхοд