Installing the Reflector, LNBF, & Feed Arm
Note that the reflector, LNBF, and feed arm are packaged separately as
1.Press and hold “POWER” for two seconds to turn on the interface box. Wait until the interface box finishes “connecting to antenna.” The TRAV’LER® antenna may enter the search routine after ten seconds. Pay attention to the pinch points as the antenna raises!
2.Wait until the antenna has at least raised to a position in which the lift arms are perpendicular to the roof. Then, press “POWER” and “SELECT” at the same time. The antenna should stop moving.
3.Unplug the interface box.
4.Insert the two longer screws into the top two holes in the front of the reflector.
5.Slide a
6.Thread a nut onto each screw; make sure the nut is tight to keep the clamp from falling.
7.Align the two anchor posts on the back of the reflector with the two notches in the skew plate (see fig. 1). Then, set the reflector on the skew plate; the reflector should be positioned with the LNB arm at the bottom of the plate. Carefully use the clamps on the back of the reflector to hold the reflector in place (see fig. 2A); make sure that the thicker part of the clamp is to the outside of the reflector.
Notches in skew plate
Anchor posts |
|
in reflector | FIGURE 1. Anchor posts and notches to align |
8.Once the top screws and clamps are in place, install the lower screws and clamps.
9.With the bracket mounted securely, connect the four coax cables to the mount (see fig. 2B).
10.Locate the cable tie on the coax cables that you just connected to the mount. Place the
11.Carefully screw this clamp to the front of the lift arm using the provided 5/16” screw (see fig. 2C). Warning: Be careful not to strip out the hole for the 5/16” screw when you replace the clamp holding the coax cables to the arm. Do not use a power tool. Do not overtighten this screw.
+
+
+
ABC
FIGURE 2. Installing reflector, LNBF, and feed arm. A, Reflector held on skew plate with clamps. B, Coax cables connected. C, P-clamp on lift arm.
12.Plug in the interface box.
13.Press and hold “POWER” for two seconds to turn on the interface box. Press the Power button again to stow the antenna.
2452259