Pioneer VP-1000 warranty Connections to Y OUR TV, Optional Connections

CONNECTIONS

CONNECTIONS TO Y OUR TV	3. Next, set your TV to channel 3 or 4, whichever is not
1. Remove your VHF antenna cable from the VHF ANT	used for commercial TV broadcasts in your area. Then
terminal(s) on your TV set, and connect the cable to the	set	VHF CHANNEL SELECTOR on VP·1000 to the
	same channel accordingly as shown in fig. 6.
ANTENNA IN terminal(s) on Vp·l000. For twin·lead
	4. Plug	AC power cord for VP-l000 into a standard wall
feeder antenna cable (300 ohms) prepare the wire leads
	socket (120V, 60Hz). This completes the standard con­
as shown in the left of fig. 4 and connect to the
	nection procedure for video and audio reproduction
ANTENNA IN 300 ohms BAL terminals. For coaxial
antenna cable (75 ohms), an F type plug must be fitted	through your TV .
to the end of the cable, as shown in the right of fig. 4, in
order to connect it to the ANTENNA IN 75 ohms UN·
BA L terminal.

2.An accessory cable with F type plugs at both ends is sup· plied with VP·l000 . Connect one end of this cable to VHF OUT terminal on VP·l000 and connect the other end to the VHF IN (75 ohms, unbalanced, F type jack) terminal on your TV set. If your TV has no F type VHF IN terminal, prepare the end of the cable as shown in fig. 5. If your TV has no 75 ohms antenna terminal, pur· chase a 75 ohms·to·300 ohms adaptor and connect the cable to the adaptor. Then connect the adaptor's twin­

lead feeder to the TV's VHF IN (300 ohms balanced)
antenna terminals.				1.		I nsert a small (flat blade) screwdriver			into	the channel
						selector open i ng.
					2 . Slide the selector to			the left (vi ewed	from	th e rear)	for
						channel 4 ; slide to the right for channel 3.
					Fig.6. Channel selector
G-~---		J.~~	O i
				1.		Stereo amplifier
					OPTIONAL CONNECTIONS
					Vp·l000 can reproduce two channel stereo hi-fi signals
	CtD do				from laser discs. To take full advantage of this capability,
					use	the	two acce ss ory audio connection cords to connect
	\ 'HF	our
					AU D 10		OUT jacks on	VP-l000 to the		left and	right
					channel AUX input (or tape or tuner input) jacks on your
					stereo amplifier or receiver.
					Place the TV set (to which you have the cable connected)
					between the two stereo speakers and shut off the TV set's
					volume control for best results.

/.i

Unit: mm

75-ohm coaxial cable preparation

1.Strip the end of the cable as shown in step 1.

2.Prepare the end as shown in steps 2 and 3.

3.Loosen the three screws, insert the cable.

4 . Tighten th e three screws firmly.

Fig.5 Connections to a standard TV set

Fig.7 Connections to a stereo pre-main amplifier

6