Installation
Note
•Check all connections and systems before final installation.
•Do not use unauthorized parts. The use of unauthorized parts may cause malfunctions.
•Consult with your dealer if installation requires drilling of holes or other modifications of the vehicle.
•Do not install this unit where:
—it may interfere with operation of the vehicle.
—it may cause injury to a passenger as a result of a sudden stop.
•Do not install the display where it may (i) obstruct the driver’s vision, (ii) impair the performance of any of the vehicle’s operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver’s ability to safely operate the vehicle.
•The semiconductor laser will be damaged if it overheats. Install this unit away from hot places such as near the heater outlet.
•Optimum performance is obtained when the unit is installed at an angle of less than 60°.
•To some types of vehicles, this unit cannot be properly installed. In such case, use the optional installation kit
•When installing, to ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents.
Leave ample space | Dashboard |
5cm |
|
10cm
English
Installation using the screw holes on the side of the unit
Fastening the unit to the factory radio-mounting bracket.
Position the unit so that its screw holes are aligned with the screw holes of the bracket, and tighten the screws at 3 or 4 locations on each side.
If the pawl gets in the way, bend it down.
Factory radio mounting bracket
Binding screw or flush surface screw
Be sure to use the
screws supplied with Dashboard or console this unit.
Note
Installation
Installing the microphone
Installation notes
Install the microphone in a position and orientation that will enable it to pick up the voice of the person operating the system.
CAUTION
It is extremely dangerous to allow the microphone lead to become wound around the steering column or gearstick. Be sure to install the unit in such a way that it will not obstruct driving.
When installing the microphone on the sun visor
1.Install the microphone on the microphone clip.
Microphone
Microphone clip
English
2. Install the microphone clip on the sun visor.
With the sun visor up, install the microphone clip. (Lowering the sun visor reduces the recognition rate for voice operations.)
Microphone clip
Clamps
Use clamps to secure the lead where necessary inside the vehicle.
When installing the microphone on the steering column
1.Install the microphone on the microphone clip.
Microphone
Microphone clip | Fit the microphone | |
lead into the groove. | ||
|
Installation | English |
2.Install the microphone clip on the steering column.
Install the microphone clip on the rear side of the steering column.
Clamps
Use clamps to secure the lead where necessary inside the vehicle.
Adjusting the microphone angle
The microphone angle can be adjusted by moving forward or backward the microphone clip angle.
In some types of vehicles, discrepancy may occur between the unit and the dashboard. If this happens, use the supplied frame to fill the gap.