Sharp MD-M2H CD Playback, MD recording and playback, Radio reception, Symptom Possible cause

Page 47

(Continued)

CD Playback

Symptom

Possible cause

Remedy

Even though a disc has been loaded, “CD NO DISC” or “ERR” is displayed.

Playback stops in the middle of a track, or playback is not performed properly.

Playback sounds are skipped.

The disc is loaded up-side down.

The disc is very dirty.

The disc which does not satisfy the standards.

Is the unit located near excessive vibrations?

Has condensation formed inside the unit?

Load the disc with the correct side up.

Clean the disc.

Load the correct disc.

Place the unit on a firm, level surface free from vibration.

Remove the disc and leave the power turned on. The unit should function properly in about 1 hour.

MD recording and playback

Symptom

Possible cause

Remedy

A recording cannot be made.

Is the MiniDisc protected against accidental erasure?

Did you try to make recording on a play-back only MiniDisc?

Can you see the “DISC FULL” or “TOC FULL ” message in the dis- play?

( :number or symbol)

Slide the accidental erase pre- vention tab back to its original position.

Replace it with a recordable disc.

Put in another recordable disc with recording space on it.

Even though a disc has been loaded, “MD NO DISC” or “READ ERR” is displayed.

Playback sounds are skipped.

The disc is very dirty.

Is the unit located near excessive vibrations?

Has condensation formed inside the unit?

Clean the disc.

Place the unit on a firm, level surface free from vibration.

Remove the disc and leave the power turned on. The unit should function properly in about 1 hour.

Radio reception

Symptom

Possible cause

Remedy

Radios make unusual noise con-

The unit is placed near the TV or

When the unit receives a radio

secutively.

computer.

broadcast near a TV set, a com-

 

The aerial direction is not placed

puter or a word-processor,it may

 

properly.

pick up noise. If this hap-

 

 

pens,try to move the unit from

 

 

the place where the noise is

 

 

picked up.

 

 

Correct the aerial direction.

The preset channel cannot be re- called.

Did you erase the programmed sta-

Preset the channel again.

tion?

Redo programming.

 

Remote control

Symptom

Possible cause

Remedy

The remote control does not func-

The batteries (polarity) are not in-

Insert properly.

tion or does not operate properly.

serted properly.

Replace the batteries.

 

The batteries inside the remote con-

Operate it within a range of 0.2

 

trol are dead.

m (8") to 6 m (20’) and within

 

The remote control is operated from

an angle of 15 ° to either side of

 

an incorrect distance or angle.

centre.

 

 

 

The power cannot be turned on

Is the AC power lead plugged in?

Connect the AC power lead.

from the remote control.

 

 

 

 

 

46

Image 47
Contents MD-M2H ContentsSpecial Notes Service InformationGeneral AccessoriesPrecautions Volume controlRear panel Names of Controls and IndicatorsFront panel Speaker section 16 17 18 19 20 21Display window Remote control Speaker connection Preparation for USEAerial connection Placing the system Removing the speaker grilles Connecting the AC power leadDemo mode Speaker cushionTo return to the original brightness Remote controlPrecautions for battery use To change the brightness of the displayTo change the clock time Setting the ClockTo change the time display mode To see the time displayExtra bass X-BASS VolumeSound Control Pre-programmed equalizerTo stop playback Compact Disc OperationCD playback To interrupt playbackTo remove a MiniDisc Minidisc OperationMD playback Cue and review Convenient CD and MD OperationApss Auto Program Search System Repeat and random playTo check which tracks are programmed To cancel the ApmsApms Automatic Programmable Music Selector To clear the programmed selectionsTime Switching the time displayChanging the display during MD playback Radio Operation TuningManual tuning Auto tuningPreset memory scan Preset tuningRT Radio Text Display ModeInformation provided by RDS PTYPage To stop the Aspm operation before it is complete To erase all of the contents of preset memoryAspm Auto Station Program Memory To cancel the station select operation Page If you have selected the traffic programme To manually recall the stations stored in memory To switch the displayPresetx W Ptyi Checking the stand-by mode settingTo cancel the EON stand-by mode About the Ptyi Dynamic PTY IndicatorEON-TI TP indicator TA indicator Meaning About the TP and TA indicatorsAbout track numbers RecordingDifferences from tape recordings Disc writing TOCTo stop recording To cancel the operationRecording from a CD onto a MiniDisc One-Touch Editing To check the remaining time available for recordingCD0MD Edit To record without using One-Touch EditingApms recording To record the track number whilst record- ing Recording from the built-in radio onto a MiniDiscType of characters used EditingWhat the editing function can do To erase a disc name To create a disc nameTo erase a track name To create a track nameExample To change BET to Best To change disc names and track namesTo add a character Name TOC Edit Enter ClearCombine When both tracks have a nameDivide Example MoveTo combine two non-contiguous tracks To erase all of the tracks at once EraseAll Erase To erase tracks one at a timeTimer playback Timer OperationTimer recording To use sleep and timer recording in com- bination Simultaneous sleep and timer op- erationTo cancel the sleep operation To use sleep and timer playback in combi- nationHeadphones Using External UnitsConnecting external units Manual recording Listening to sound from an exter- nal unitWhat is a MINIDISC? Mini Disc System Limitations TroubleshootingIf a problem occurs Symptom Possible cause RemedyRadio reception Symptom Possible causeCD Playback MD recording and playbackWhen an error message is displayed, proceed as follows Error MessagesCare of compact discs MaintenanceInternal care External careSpecifications Memo Terms of Guarantee

MD-M2H specifications

The Sharp MD-M2H is a versatile portable MiniDisc recorder that gained popularity for its compact design and advanced features, catering to music lovers and professionals alike. One of the standout features of the MD-M2H is its ability to record audio in high-quality formats, offering both stereo and mono options. This flexibility appeals to various users, including musicians, journalists, and audiophiles seeking pristine sound quality.

Equipped with a digital input, the MD-M2H allows users to connect directly to other digital devices, ensuring minimal loss of audio quality during transfers. The device also supports a unique ATRAC (Adaptive Transform Acoustic Coding) compression algorithm, which maintains the integrity of the original recording while significantly reducing file sizes. This technology enables longer recording times on a single MiniDisc, making it ideal for extended sessions.

Another important aspect of the MD-M2H is its user-friendly interface. The device features an intuitive control layout that facilitates easy navigation through its various functions. With an LCD display, users can easily monitor battery life, recording time, and other essential information at a glance. The inclusion of external microphone inputs adds to its adaptability, allowing for enhanced audio capture in diverse environments.

The Sharp MD-M2H is powered by rechargeable batteries, appealing to environmentally conscious users while providing the convenience of extended playback and recording times. Its compact and lightweight design, combined with a robust build, makes it perfect for on-the-go recording, whether that’s in the studio, at concerts, or while traveling.

In summary, the Sharp MD-M2H stands out for its high-quality audio recording capabilities, user-friendly design, and advanced compression technology. Its adaptability makes it a valuable tool for a wide range of applications. Whether for personal use or professional purposes, the MD-M2H continues to impress with its performance and reliability, cementing its place in the world of portable audio recording.