Installation, DIN front/rear mount | Pioneer DEH-2150UB manual

Section

04Installation

Important

!Check all connections and systems before final installation.

!Do not use unauthorized parts. Use of un- authorized parts may cause malfunctions.

!Consult your dealer if installation requires dril- ling of holes or other modifications to the vehi- cle.

!Do not install this unit where :

—it may interfere with operation of the vehi- cle.

—it may cause injury to a passenger as a re- sult of a sudden stop.

!The semiconductor laser will be damaged if it overheats. Install this unit away from hot places such as near the heater outlet.

!Optimum performance is obtained when the unit is installed at an angle of less than 60°.

space behind the unit, use factory supplied mounting sleeve.

2Secure the mounting sleeve by using a screwdriver to bend the metal tabs (90°) into place.

3Install the unit.

Dashboard

Rubber bush

Mounting sleeve

Screw

60°

!When installing, to ensure proper heat disper- sal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents.

Removing the unit

1Extend top and bottom of the trim ring outwards to remove the trim ring. (When reattaching the trim ring, point the side with a groove downwards and attach it.)

DIN front/rear mount

This unit can be properly installed either from “Front” (conventional DIN front-mount) or “Rear” (DIN rear-mount installation, utilizing threaded screw holes at the sides of unit chas- sis). For details, refer to the following installa- tion methods.

Trim ring

!It becomes easy to remove the trim ring if the front panel is released.

2Insert the supplied extraction keys into both sides of the unit until they click into place.

3Pull the unit out of the dashboard.

DIN Front-mount

Installation with the rubber bush

1Insert the mounting sleeve into the dashboard.

When installing in a shallow space, use a sup- plied mounting sleeve. If there is enough

20 En