FITTING
Carefully cut open the headrest cover
Use a knife with an adjustable cutting depth to cut out the planned area.
➮Make the first cut inside the marked area at a point about 0.5 cm from one of the corners, then make a diago- nal cut to a point about 0.5 cm from the opposite corner.
➮Make a similar cut between the oth- er two diagonally opposed corners.
Open the headrest and remove filling and other items
➮Carefully lift the covering material away from the cut area.
➮Adjust the cutting depth of the knife to about 2.5 cm, and cut into the he- adrest following a line about 0.5 cm inside the marked edge.
➮Carefully lift the filling material at one corner, and cut deeper into the ma- terial with the knife.
➮Remove the filling material in small pieces.
➮As you do this, lift one piece of the filling material, and ensure that the cut is being made to an even depth.
To remove other pieces, use a Dremel saw or another suitable tool.
➮Insert the monitor to check that it will fit into the cut area, and make ad- justments if necessary.
18