Installation—Seat Head Rest
1Pull the connecting cable assembly through the LCD mounting shroud as shown below.
2.Connect the Din interface cable to the cable from the monitor.
3.To install the monitor into the seat head rest you must ensure that the moni- tor connecting cable assembly has already been pulled through the mounting shroud and the head rest support tube. (As an alternative the cable can be routed beside the headrest support tube.)
4.Ensure that the the cable assembly is routed to prevent damage when the seat is adjusted. If the connecting cable is routed along side the headrest support tube ensure that it routed so that it will not be damaged when the headrest is adjusted.
MOUNTING |
|
SHROUD | HEADREST |
| 1 | DIN | 2 | |
|
| |||
| CONNECTOR |
| ||
DIN |
| ELECTRICAL | 3 | |
CONNECTOR | LCD CABLE | CABLE | ||
| ||||
|
| HEADREST | ||
|
|
| ||
|
|
| SUPPORT TUBE |
5.Place headrest shroud into the opening and secure it with correct fasteners.
6.Ensure that there is no foreign objects or other material trapped inside the LCD mounting shroud before pushing the monitor onto the shroud. Make sure that the monitor securely locks in place in the shroud.
6 5
MONITOR
MOUNTING
SHROUD
© 2005 Directed Electronics, Inc. | 7 |