TROUBLESHOOTING
PROBLEM | SOLUTION |
IR remote inoperative | — Verify that the batteries in the remote are fresh. |
| — Verify that the remote sensor eye is not obstructed. |
| — Verify that the correct mode (M1 or M2) has been selected. |
|
|
Disc won't play | — Insert a disc with the label side facing up. |
| — Check the type of disc you put into disc tray. This DVD only plays DVDs, audio CDs |
| and MP3s. |
| — Both the unit and the disc are coded by region. If the regional codes don’t match, |
| the disc can’t be played. This DVD player is set to Region Number 1. |
|
|
Play starts, but then stops immediately | — The disc is dirty. Clean it. |
| — Condensation has formed. Allow player to dry out. |
|
|
No sound or distorted sound | — Make sure your DVD is connected properly. Make sure all cables are securely |
| inserted into the appropriate jacks. |
| — If you are using the |
| headphone power, and make sure the correct channel |
| — Make sure the Modulator is ON and the proper Frequency has been selected. |
| — Make sure that unit is set to M1 when using Single Channel Headphones. |
|
|
Can’t advance through a movie | — You can’t advance through the opening credits and warning information that |
| appears at the beginning of movies because the disc is programmed to prohibit that |
| action. |
|
|
25