Plantronics 50-0230B-004, 50-0230B-003, 50-0230B-002 Preparation of Vehicle Interior

Page 3

I. PREPARATION OF VEHICLE INTERIOR

1.Remove the O.E.M. console mounted to inner roof of vehicle. Remove and discard (1) one screw from recess in front of console near rear view mirror. Disconnect wire harness and

remove console from vehicle. Use care not to

damage A/C control head. See Figure 1.

FIGURE 1

2.Remove A/C control head from cloth covered trim ring on O.E M. console by depressing (4) four tabs on back of control assembly.

See Figure 2. Discard cloth covered trim ring.

FIGURE 3

3

FIGURE 2

3.Remove and discard O.E.M. dome light by removing center cover and (2) two screws. Disconnect wire harness. See Figure 3.

4.Carefully remove and retain bezel from rear A/C control head and lay it in a safe place. See Fig. 3.

5.Remove and retain rear A/C control head and lay it in a safe place. See Figure 3.

Image 3
Contents Suburban QTY Materials Provided for InstallationPreparation of Vehicle Interior Page Page III. Installation of Console II. Preparation of Console for InstallationPage Important Torque Seat Belt Bracket to MFG Specification