Planar PT1710MX manual Connecting the Display Figure

Page 15

11

￿Connecting the Display (Figure 11.1)

To setup this display, please refer to the following figure and procedures.

1.Be sure all equipment is turned off.

2.Connect the DC power cord to the power connector on the monitor; plug one end of the AC power cord into the power adapter, and the other end into an electrical outlet (11.1￿).

3.Connect the VGA signal cable from the display’s VGA input connector to the 15-pin connector of your host computer and tighten the screws (11.1￿).

4.Connect the Audio-In cable from the audio input port of your display to the Audio-out port of your computer (11.1￿).

5.Configure the touch screen. Refer to the “Touch Screen Driver Installation section on page 20.

6.Once the touch screen is configured, the monitor is ready for use.

To ensure the LCD display works well with your computer, please configure the display mode of your graphics card to make it less than or equal to 1280 x1024 resolution and make sure the timing of the display mode is compatible with the LCD display.

We have listed the compatible “Video Modes” of your LCD display in the appendix for your reference.

Image 15
Contents Touchscreen LCD Monitors Page Important Recycle Instructions Page Table of Contents Usage Notice PrecautionsAbout Planar’s PT1710MX IntroductionTouch Screen for PT1710MX Package Overview Product Overview InstallationUSB Kensington Security Slot Vesa Mount Your Monitor Remove the Back Cover Start Your InstallationConnecting the Display Figure Page Front Panel Controls User ControlsHow to Use the OSD Menus On-Screen Display Menus Appendix TroubleshootingNo Signal Product Dimensions Compatibility Modes Mode Resolution Frequency KHzDriver Installation Process Touch Screen Driver InstallationPT1710MX Optional Resistive Calibration Tool Install Using the RS232 connection Planar Support Product Registration and Technical SupportPage PT1710MX 触摸屏液晶显示器的注册商标。 前注意事项 兼容性模式 显示屏表面。 产生强磁场的电器的附近。 阳光直射。 Planar PT1710MX简介 像素点距线电阻式触摸屏,配有双 控制器 内置扬声器 PT1710MX触摸屏 控制器VGA液晶 显示 器 后视图 端口 A(后盖内侧) B音频 Kensington 警请告选!择正确的螺丝! 后请盖使表用面直与径螺最丝长孔为底8 mm部之的间M4的螺距丝离。为 。 理线槽依序排列线缆。 包含有理线槽 您可以平放液晶显示器,以便它可以连接线缆。确保将它放在一个平 整的表面上,以免刮碰造成液晶显示器损坏。 针接口,并 11.1 VGA 线 显示图像 Page 菜单会自动关闭。 默认为 默认为100 显示器的显示 问题:图像(字符和图形)不清楚 信息。 产品尺寸 兼容性模式 串行连接线与 按照以下说明步骤进 Finish行操作。 绘图测试 打开计算机。 产品的商店。 适配器 Page 电话:
Related manuals
Manual 29 pages 40.72 Kb