Interface for Arm Applications, Cable Installation

Interface for Arm Applications

Before installing to mounting device, please refer to Fig.1-2.

The rear of this LCD display has four integrated 4 mm, 0.7 pitches threaded nuts, as well as four 5 mm access holes in the plastic covering as illustrated in Figure 1-3. These specifications meet the VESA Flat Panel Monitor Physical Mounting Interface Standard (paragraphs 2.1 and 2.1.3, version 1, dated 13 November 1997).

Note :Please using Ø 4mm x 8mm (L) screw for this application.

Cable Installation

Please follow these instructions to install the cables.

1.Remove the back panel n from the rear of the monitor.(See Fig. 1-4)

2.Place the signal cable, the AC power cable into their correct Socket.

Figure 1-3

Figure 1-4

Connecting the Display to your Computer

1. Power off your computer.

2. Connect one end of the signal cable to the LCD Monitor’s VGA port (See Fig 1-5)

3. Connect the other end of the signal cable to the VGA port on your PC.

4. Make sure connection are secure.

Figure 1-5

Attention

This device must be connected to an off-the-shelf video cable in order to comply with FCC regulations. A ferrite-core interface cable is included in the LCD Monitor package.

This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used.

Connecting the AC Power

1. Connect the power cord to the AC socket.(See Fig. 1-6)

2. Connect the power cord to an AC power source.

Figure 1-6

Setting Up the LCD Monitor

1. Turn on the LCD monitor’s hard power switch, located on the back of the monitor (See Fig. 1-7)

2.Turn on the LCD Monitor's soft power switch, located on the

bezel of the monitor.

Figure 1-7