Planar LX1200TI manual Connecting the Monitor

Step 3 - Connecting the Monitor

Once the LX1200TI is mounted in place, connect it to the computer (or other video source) and the 12 VDC power supply as follows.

Note: This procedure refers to connections to and from the computer. However, depending on your particular hardware configuration, these connections may be to a dock or other device rather than directly to the computer.

1.As needed, route any data and power cables from the computer to the monitor.

2.Make sure the computer is turned off.

3.Connect the 12 VDC power supply cable to the monitor’s power supply.

Note: Use a 5-Amp fuse in line to the power source.

Also, to prevent vehicle battery from draining, you should install a device that shuts off power to the monitor while the monitor is inactive. (An example is Lind Electronic’s Vehicle Battery Voltage Shutdown Timer - www.lindeletronic.com).

4.Connect the power supply and power interrupt cables (for the All-in-One power switch, if your computer or docking station is so equipped) to the connectors on the bottom of the monitor. See the following diagram for connector locations.

Speaker Vent

Volume Dial

USB Type A

Dimming Dial

USB Type A	VGA	Audio
USB Type B Upstream	Power 12 V	Remote PC Shutdown/Start

LX1200TI User’s Guide (020-0512-02A) 17