Planar CT1904Z About this manual, FCC Compliance Statement, Preface

Page 3

Preface

PREFACE

About this manual

This manual is designed to assist you in setting up and using the LCD monitor. Information in this document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. The information in this document is subject to change without notice. This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic or other means, in any form, without prior written permission of the manufacturer.

Copyright

Copyright 2001, All Rights Reserved

FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Opeartion is subject to the following two conditions:

1.this device may not cause harmful interference, and

2.this device must accept any interference received, including interference that may cause undesired operation.

FCC WARNING

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inerference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Caution:

To comply with the limits for an FCC Class B computing device, always use the shielded signal cord supplied with this unit.

The Federal Communications Commission warns that changes or modifications of the unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

CE mark for Class B ITE (Following European standard EN55022/1998; EN61000-3-2/1995; EN61000-3-3/1995, EN55024/1998, EN60950/1992+A1+A2+A3+A4+A11)

Radio Frequency Interference Statement

Warning:

This is a Class B product. In a domestic environment, this product may cause radio interference in which case the user may be required to take adequate measures.

i

Image 3
Contents Planar LCD Monitor CT1904Z Manual Page Preface About this manualFCC Compliance Statement Radio Frequency Interference StatementCanadian Doc Notice Important Operating InstructionsPlanar User’s Manual Table of Contents Page Identifying Components LCD MonitorYour New Planar LCD Monitor UnpackingDC Power Jack Adjust Control ButtonsPower LED Power Mode IndicatorAudio Line-in optional Adjusting the Viewing AngleConnecting AC Power VGA Cable ConnectorConnecting the Stereo Speakers Connecting VideoPower Management System Your New Planar LCD Monitor’s Display Controls Adjusting the Monitor’s DisplayOSD Main Menu Analog mode Display ControlsAuto Adjust Procedure Main FunctionsMonitor- Control Option OSD Control Option Misc. Control OptionGraphic Control Option Chapter OSD Exit OSD Main Menu Digital modeDigital 5-topline menus are Planar User’s Manual Graph/Text OptionPort-SelectPress the Adjust buttons to change input VGA port Planar User’s Manual Technical Information TFT LCD Monitor SpecificationsSupported Timing Timing for Model CT1904Z Sxga ResolutionTroubleshooting Procedures Troubleshooting