DIN FRONT- MOUNT (Method A)
Installing the unit
1 | 2 |
1. Dashboard
2. Holder
After inserting the holder into the dashboard, select the appropriate tab according to the thickness of the dashboard material and bend them inwards to secure the holder in place.
3. Screw
3
USING THE RESET BUTTON
Press button with a thin, pointed object if unit is malfonctioning. Though not a normal occurrence, the microprocessor which controls the operation of this unit can be affected by electrostatic noise.
This generally is indicated by such symptoms as no power being supplied when you switch the unit on, failure of buttons and controls, or an abnormal display.
Should this happen, press the reset button with a thin, pointed object to reset the microprocessor.
1
6
7
1.Dashboard
2.Nut (5mm)
3.Spring washer
4.Screw (5 x 16mm)
5.Screw
6.Strap
Be sure to use the strap to secure the back of the unit of the place. The strap can be bent by hand to the desired
FLASHINGRESET
2
5
angle.
7.Plain washer
3
1 
3
1.Frame
2.Insert fingers into the groove in the front of frame and pull out to remove the frame .(When
3.Lever
Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click.
Pulling the levers makes it possible to remove the unit from the dashboard.
SPECIFICATIONS
MW(AM) SECTION |
|
Frequency Range | : 530 - 1710 KHz |
Channel Step | : 10 KHz |
Intermediate Frequency | : 450 KHz |
Usable Sensitivity | : 33 dB |
Image Rejection Ratio | : >50 dB |
If Rejection Ratio | : >50 dB |
FM SECTION |
|
4 SPEAKER WIRING
CONNECTIONS
Frequency Range | : |
Channel Step | : 200 Khz |
Intermediate Frequency | : 10.7 MHz |
Image Rejection Ratio at 106KHz | : >50 dB |
Signal to noise ratio | : >60 dB |
ANTENNA |
|
|
| ||
RED(R) |
|
|
|
|
|
|
|
|
|
| |
LINE OUT |
|
|
|
| GRAY |
|
|
|
| ||
WHITE(L) |
|
|
| ||
|
|
|
| ||
RED(R) |
|
|
|
| |
|
|
|
|
| |
LINE IN |
|
|
|
| BLACK |
|
|
| |||
WHITE(L) |
|
|
| ||
|
|
| |||
|
|
|
| ||
FRONT | + WHITE |
LEFT |
|
SPEAKER | - WHITE/BLACK |
| |
REAR | + GREEN/BLACK |
LEFT |
|
SPEAKER | - GREEN |
|
|
|
|
| BLACK |
|
|
| FUSE | ||
|
|
| 0.5A | BLUE | |
|
|
| AUTO ANT(+) | ||
|
|
| 1A | RED | |
|
|
| B (+) | ||
|
|
|
|
| |
|
|
| 7A | YELLOW | |
|
|
| BACK UP | ||
|
|
|
|
| |
|
| GRAY + | FRONT | ||
|
|
|
|
| RIGHT |
| GRAY/BLACK- | SPEAKER | |||
|
| VIOLET + |
| REAR | |
|
|
|
|
| RIGHT |
| VIOLET/BLACK- |
| SPEAKER | ||
CD PLAYER SECTION |
|
Signal to noise Radio | : More than 60dB |
Channel separation | : More than 60dB |
Frequency Response | : 20Hz - 20KHz |
GENERAL |
|
Power Supply Voltage | : DC 12 Volts Negative Ground |
Speaker impedance | : 4 - 8 |
Maximum Output Power | : 15W x 4CH |
Dimensions Chassis | : 178(W) x 50 (H) x 160(D)mm |