Marshall electronic V-RD171P-HDA warranty Operational Setup, Connectors

4Operational Setup

1.Unpack the V-RD171P-HDA and accompanying power supply. Physically inspect for any damage that may have occurred during shipping. Should there be any damage, immediately contact Marshall Electronics at 800-800-6608. If you are not located within the continental United States call +1 310-333-0606.

2.Install in your desired location.

3.Connect required cables for signal input and output.

4.Attach power connector from power supply to the back of the unit.

5.Plug the power supply into the A.C. source

6.Turn on the V-RD171P-HDA by pressing the power switch located on the front of the unit. Refer to picture below for location of switch settings.

7.Perform input selections and screen adjustments as detailed in the following sections of this document.

5Connectors

Composite Video	12 VDC from
75Ω Terminated	power supply

DVI-D in VGA in

6Front Panel Indicators and Controls

Component Video	S-Video
75Ω Terminated	75Ω Terminated

Power On/Off selection button

Illuminates bright red when power is applied.

Turns dim red when monitor is switched on

On Screen Display (OSD)

MENU Activation Button

Dual Function EXIT button 1- Cycles Input selection

(Selection Displayed lower right of screen)

2- Exits OSD Menu Mode

UP / DOWN / LEFT / RIGHT

menu selections for OSD functions

Marshall Electronics 3