Audiovox VOH683, VOH704, VOH684 owner manual

Ac cess ory Harnes s Item # 2

Power Connector

4 Pin

VOH683	exiting the pod
	Note: cables
	should be routed
	as shown.

	Red : +12 VDC			Pow er Harne ss			12 Pin Power signal
				Item # 4			Harness Item #3
	(A ccesso ry Cir. )
						c h ok e
	Black: G rou n d
				Optional Hard W ired FM Modulator Output
	12 VDC Power and Ground					RCA -Female
						Left
	A m /Fm					In put	L EFT
TO	A nte nn a			F M
							WHITE
				M od ulato r		Patch Cord
FAC TO R Y							RIGHT
			1 07 0 6 1 0			RCA Male to Male
RA D IO	D as h R a dio					Right	R ED
		*Refer to Instructions with the RF
						In put
		Modulator Kit for further details.				RCA -Female
				To Secondary AV Monitor
TO	12 VDC Power and Ground				IN PUT	RCA -Female
O P TIO N A L					VIDEO
							LINE
A D D IT IO N A L
		A ux illa ry					OUT
M O IN TO R						Patch Cord
		vide o d is pla y					VIDEO
						RCA M ale to Male

Mini-Din Connectors

2 1

Connect to FM radio antenna or equiv alent.

Ac cess ory Harnes s Item # 2

Red RCA (Audio Right)

White RCA (Audio Left)

Yellow R CA (Video)

Optional Remote H eadphone Stations
Stereo	Green
Hea dpho ne Jack	(Right+)
Stereo	Black
Hea dpho ne Jack	(Ground)
	Gray
	(Left+)

IR LED :

Clean the IR R eceiver Window on the front of the V CP. Rem ove A dhesive Backing and Apply IR LED to IR Window on the Fac e of the V CP.

"Y " Adapter fo r use with Non-Stereo In stallations Item# 5

Figure A

1)Make the connections to the vehicle for the 12 pin wiring harness.

2)Remove screws on PCB Cover. Open the cover to gain access to Mini-Din Connector on main PCB.

3)Insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB.

4)Pull the wire tie loop tight and cut off the excess.

5)Connect the 12 pin harness to the mating connector on the Video Monitor.

6)Connect the wired RF Modulator and / or the remote headphone jacks to the video monitor if those options are being included.

7)Connect power harness to vehicle’s electrical system by tapping into an accessory hot line.

8)Reinstall PCB cover using the 2 screws.

9)Connect FM radio antenna to the existing vehicle antenna or equivalent using the supplied 144" Adapter Cable and the "Y" Adapter (Refer to Figure C.)

10)Verify all functions of the System before final mounting of the finished assembly.

Note: A second VCP or other A/V Component can be connected to the video monitor system using a

second source component harness (purchased separately, part number: 8010730). This second har- ness would plug into the second Mini-Din connector on the main PCB as in steps 2 and 3 above.

A/V Source Definitions:

1= VCP (Right Mini-Din on main PCB)

2= 2nd VCP (or game or DVD, etc.…. left Mini-Din)

-6-