Audiovox VOD1023 P, VOD1023 S manual Mini Console Installation

Page 6

MINI CONSOLE INSTALLATION:

This page only covers special installation considerations for the mini-console installation. If the video monitor is to be installed in a vehicle with the mini console, this console may need to be trimmed to fit the contour of the vehicle headliner.

1)In this installation, the video monitor is mounted directly to the overhead cross-member in the roof using the mounting screw bosses. These screw bosses should contact the cross-member di- rectly (i.e.: no gap between the screw boss and the roof structure). Also, be sure that the screws do not pierce the outer roof skin when fully fastened to the cross-member. The mini-console is attached to the video monitor using the perimeter screw bosses. It is important that the screws used in this installation are not overtightened, and that the video monitor and mini-console are mounted in such a way that the assembly does not distort (or bend) when the mounting screws are tightened. An alternate method is to use a piece of plywood (12"x9"x3/4"). First secure the plywood block to the cross-member, then screw the monitor into the plywood. See the drawing on page 5.

2)It is best to mount the video monitor to the roof structure without the mini-console first. There should be a gap between the headliner and the outer flange of the video monitor. The mini-console should be cut to full this gap. Apply masking tape to the outer surface of the mini-console in the areas where the cut will be made.

3)Mark the cut to follow the necessary contour of the roof. The suggested method of marking is as follows:

A)First mark the narrowest point of the mini-console on the masking tape. Be careful to consider not only vertical location, but fore-aft location.

B)Using the handle of a screwdriver, make a “transfer marking tool”. See diagram below. Place the tool against the roof and the marker against the masking tape on the mini-console. Trace the cut to be made around the entire perimeter of the mini- console.

C)Cut the mini-console using a sharp utility knife or shears. Make the cut in several passes over the marked line, each time cutting a little deeper. It is not necessary to cut completely through the plastic, the cut only need be over 50% of the wall thick- ness of the plastic. By bending the cut back and forth several times, the plastic will break cleanly at the cut.

D)Check the fit of the trimmed console and make any minor adjustments necessary.

4)The mini-console can be painted or covered with a material that matches the headliner before assembling the mini-console to video monitor.

5)The finished mini-console should be attached to the video monitor, then attach the assembly to the roof.

Headliner

CutLineline

LowestPoint Markpoint mark

Figure 6

Refer to Fig 7 for detail on attaching

Tapemarkermarkerto screwdriverto startingscrewdriverat . Startingconsoleatto yourvideo podmarkand video pod to

your mark for the lowest point, then

tracefor thecontlowestur of the roofpoint, trace the contourvehicleofstructurethe roof.

-4-

Image 6
Contents Installation Guide Important Notice Materials Included in this Package Tools RequiredGeneral Installation Approach General System ConfigurationsVehicle Preparation Mini Console Installation Mounting the MINI-CONSOLE VOD1023 Connecting the Dome Lights Positive Switched Dome lightingTroubleshooting 128-7257A
Related manuals
Manual 11 pages 37.79 Kb