5)Route the wiring harnesses throughout the vehicle as necessary. (Refer to the Wiring Diagrams on page 10 of this manual as well as the wiring instructions for the individual components and accessory options being installed). Be sure that all wiring is protected from sharp edges and is routed in such a manner that it will not be pinched when all components and interior trim are fully installed. Be sure to leave enough slack in the wiring at each component to allow working room.
Note: If the vehicle is equipped with Side Curtain Air Bags, do not run wires in the vacinity of the Side Curtain Air Bags.
6)Remove all A/V system components from their packaging and place them loosely in the vehicle at their respective locations.
7)Connect all components together (electrically) and verify proper op- eration of all system functions. Note: This is best done BEFORE components have been permanently mounted.
8)After verifying proper operation of the system, proceed to mount each of the components.
9)When all components are mounted, recheck the entire system again to ensure that no wiring was pinched or connected improperly dur- ing final installation.
7