Audiovox VOH703 owner manual

Accessory

Harness

Item# 2

Power Connector 4 Pin

VOH703

Note: cables exiting the pod should be routed as shown.

TO FACTORY RADIO

									12 Pin Power signal
									Harness Item #3
Red: +12 VDC					Power Harness
					Item # 4
(Accessory Cir.)
							choke
Black: Ground
				Optional Hard Wired FM Modulator Output
	12 VDC Power and Ground							RCA-Female
						Left
	Am/Fm					Input
				FM
	Antenna										LEFT
				Modulator				Patch Cord		WHITE
										RIGHT
			1070610					RCA Male to Male
Dash Radio						Right					RED
		*Refer to Instructions with the RF
		Modulator Kit for further details.				Input		RCA-Female

To Secondary AV Monitor

Mini-Din Connectors

2 1

TV antenna (If applicable)

TO	12 VDC Power and Ground		INPUT		RCA-Female
OPTIONAL			VIDEO
ADDITIONAL		Auxillary						LINE
							OUT
MOINTOR		video display				Patch Cord	VIDEO
				RCA Male to Male

Accessory

Harness

Item# 2

Red RCA (Audio Right)

White RCA (Audio Left)

Yellow RCA (Video)

Optional External Speakers

Green (Right+)

Black

(Ground)

Gray

(Left+)

IR LED:

Clean the IR Receiver Window on the front of the VCP. Remove Adhesive Backing and Apply IR LED to IR Window on the Face of the VCP.

"Y" Adapter for use with Non-Stereo Installations

Item# 5

1)Make the connections to the vehicle for the 12 pin wiring harness.

2)Remove screws on PCB Cover. Open the cover to gain access to Mini-Din Connector on main PCB. (Cover will remain attached to rivet hole).

3)Insert the Circular Mini-Din Connector of the source Component Harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB.

4)Pull the wire tie loop tight and cut off the excess.

5)Connect the Power Harness to the mating connector on the Video Monitor.

6)Connect the wired RF Modulator and / or the remote headphone jacks to the video monitor if those options are being included.

7)Connect power harness to vehicle’s electrical system by tapping into an accessory hot line.

8)Reinstall PCB cover using the 2 screws.

9)Mount and connect the Television antenna.

10)Verify all functions of the System before final mounting of the finished assembly.

Note: A second VCP or other A/V Component can be connected to the video monitor system using a

second Source Component Harness (purchased separately, part number: 8010730). This second harness would plug into the second Mini-Din connector on the main PCB as in steps 2 and 3 above. A/V Source Definitions:

1= TV Tuner

2= VCP (right Mini-Din on main PCB)

3= 2nd VCP (or game or future DVD, etc.…. left Mini-Din)

-6-