AOC e2040S manual Regulation, FCC Notice

Page 54

Regulation

FCC Notice

FCC Class B Radio Frequency Interference Statement WARNING: (FOR FCC CERTIFIED MODELS)

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

NOTICE :

The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Shielded interface cables and AC power cord, if any, must be used in order to comply with the emission limits. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modification to this equipment. It is the responsibilities of the user to correct such interference. It is the responsibility of the user to correct such interference.

54

Image 54
Contents Page Page Page Safety National ConventionsPower Installation Cleaning Other Setup Contents in BoxSetup Stand & Base Adjusting Viewing Angle Connecting the Monitor Windows Vista AdjustingSetting Optimal Resolution For Windows VistaClick Display Settings Windows XP For Windows XPWindows ME/2000 Click SettingsClick Settings Click Control Panel For Windows ME/2000Auto configure hot key HotkeysOr wide image ratio hot key OSD Setting Basic and simple instruction on the control keysLuminance DCR Image Setup Clock 100 Adjust Picture Reduce Vertical-Line noise Phase Color Temperature Srgb Color Boost Page Picture Boost Page OSD Setup OSDOSD Extra DDC-CI Reset Reset Yes or no Reset the menu to default Exit LED Indicator Status LED Color Full Power Mode BlueDriver Monitor DriverWindows Click the Monitor tab and then click the Properties button Page Page Windows Vista Page Windows XP Page Page Windows ME Menu Troubleshoot Missing one of the primary Monitor Is Stuck In ActiveOff-Mode Colors RED, GREEN, orSpecification General SpecificationPreset Display Modes FREQUENCYkHZ FREQUENCYHzPin Assignments Plug & Play DDC2B Feature Plug and PlayRegulation FCC NoticeWeee Declaration Epeat Declaration Service Warranty Statement for EuropePage Page Page Warranty Statement for AP How to get your Warranty ?