Exposure Cable EL
All Hasselblad EL models except the ELD require an Exposure Cable EL.
Illustrated here also is use of the Adapter EL to hold the battery.
•Only the single shot function (A or AS mode camera settings) should be set on the camera. Rapid sequence shots are not possible.
•Use the Adapter EL (supplied) to provide the necesssary extension beyond the motor housing of the EL models for battery attachment. It is attached to a CF digital back in the same manner as a battery, and the battery itself is then attached to the adapter as in the illustration.
ELX
For use with 500EL/ELM and 500/553ELX models:
•Make an ELX setting.
•The Exposure Cable EL (supplied) should be connected.
•All exposures times, including the B setting, function correctly without having to alter the “Exposure Time” setting.
•Rapid sequence shots are not possible.
•Use the Adapter EL (supplied) to provide the necesssary extension beyond the motor housing of the EL models for battery attachment. It is attached to a CF digital back in the same manner as a battery, and the battery itself is then attached to the adapter as in the illustration.
Pinhole
For use with lenses/cameras with no shutter. Intended primarily for use in a studio en- vironment where complete darkness can be achieved and exposures made accordingly (also useful for ‘light painting’). In this mode a CF digital back uses the exposure time (as well as other required stages in a capture sequence) set in the Capture Sequence dialog. The back can be triggered either via theSTART (MENU/EXIT) button or from FlexColor (see later section for full description of Capture Sequence settings procedure).
Flash sync
For use with an ArcBody, a FlexBody or view cameras with a Hasselblad adapter.
•Make a Flash sync setting.
•A Flash sync input cable should not be used.
•All exposures times, including the B setting, function correctly without having to alter the “Exposure Time” setting.
•Do not use a winder at rapid sequence setting.
500
For use with 500C/CM, 501C/CM and 503 CX/CXi/CW models.
• Make a 500 setting.
H
• Make an H setting.
Shutter Delay
There can be differences in the amount of time required in preparation (raising the mirror, opening/closing the shutter etc) for digital capture between various camera models. This corrective feature adjusts the time a little to ensure the image is read out from the sensor. The normal setting is Default and should only be changed if problems are encountered.
Exposure Time
This setting should be changed for
48