EverFocus EDR410H Wireless of the Network Setup MENU, we define, Authentification, Wpapsk/Tkip

Page 57

3.7.5 WIRELESS

In the WIRELESS of the NETWORK SETUP MENU, we define:

Diagram 3.14

1.DHCP: Enable or disable the Dynamic Host Communication Protocol.

YES: Enable DHCP service. NO: Disable DHCP service.

2.IP ADDRESS: Assign an IP address for this unit, for example: 192.168.010.200 When DHCP is YES, the DHCP server will assign this value automatically.

3.SUBNET MASK: Assign a subnet mask of the network for this unit, for example: 255.255.255.0. When DHCP is YES, the DHCP server will assign this value automatically.

4.GATEWAY: Assign a default gateway for this unit, for example: 192.168.010.001 When DHCP is YES, the DHCP server will assign this value automatically.

5.DNS SERVER: Assign a DNS server for this unit, for example: 168.195.001.001 When DHCP is YES, the DHCP server will assign this value automatically.

6.MODE: STA stands for Station (cannot be changed)

7.AUTHENTIFICATION:

Select from OPEN/NONE, OPEN/WEP, SHARED/NONE, SHARED/WEP or

WPAPSK/TKIP.

Open: no need of shared key.

Image 57
Contents EDR810H/EDR810M EDR410H/EDR410M EDR 810H/810M/410H/410M Instruction Guide Federal Communication Commission Interference Statement Page Table of Contents Interface Specifications Everfocus Ddns SetupPlayback Overview Call OverviewAppendix a Remote Control Appendix B Alarm Board ConfigurationTroubleshooting Safety Warning Safety Precautions Safety Precautions Product Overview FeaturesSpecifications CH4 / Play Play Back Front Panel KeypadsPage Jog Dial Shuttle and Jog DialBack Panel Connections Setup Menu PowerAlarm INPUT/OUTPUT MonitorLAN For mobile model only Monitor DisplayPage TIME/DATE Setup Menu Play Date Play Status Play Time Play dateRecord status bar GPS orientation Installation PackingII System Floorplan Basic Wiring Instructions Call Monitors Final Install Process Hard Disk Drive InstallationQuick Installation Guide Quick Installation Guide for EDR810M & EDR410M only Equipment Required  Unpack EverythingPage Page  Installing the Cameras and Monitor DVR Menu Setup Time/Date Setup Menu END Time To set the end of daylight saving Page DAY Week Month Camera Setup Menu Lower Action REC Speed & ActionSummary Record Audio Record Setup MenuTime Stamp Time Stamp PositionPRE-ALARM Recording Record ModeWater Mark Relay OUTAlarm Setup Menu Alarm Email None = not activated, 1 = output signal 1 transmittedLOG DurationPage Motion Setup Menu Motion Delay Alarm NetworkPage Videoloss Videoloss Setup MenuPage Config Network Setup MenuConfig of the Network Setup MENU, we define IP ConfigGateway Subnet MaskDNS Server Remote Relay ControlMAC Addr BW ControlAlarm Network Smtp Server AuthenticationPort Number UserSender Email Addr Password of the Network Setup MENU, we defineAuthentification Wireless of the Network Setup MENU, we defineSelect from OPEN/NONE, OPEN/WEP, SHARED/NONE, SHARED/WEP or WPAPSK/TKIPNetwork Type PPPoE PPPoE of the Network Setup MENU, we defineDdns of the Network Setup MENU, we define DdnsRecord ID Record ID Everfocus Ddns 8 GPS GPS of the Network Setup MENU, we defineAutomatic GPS Transmission ProtocolMinutes 00 ~ Schedule Setup MenuMinutes 00 ~ Disk Video Delete Press Select to start delete Disk Setup MenuPage Control Setup Menu RS485 FAN Fault Network Alarm HDD TempSend Email Stop Record SET TemperatureNo HDD HDD Full Network Alarm LOAD/SAVE Configuration System Setup MenuSystem Password Enable Delete disk in Disk Setup MenuUser Level and Right Instant N Recording Setup Recording OverviewPress the Record key to start recording immediately Schedule Recording Setup Event Recording Setup Diagram Page Basic Playback Playback OverviewPlayback StopSlow Forward/Reverse Playback Fast Forward/Reverse PlaybackImage advance Forward/Reverse Search Playback Search MenuTime / Date Search Playback Event AlarmMotion VlossPage USB slot Copying VideoDevice Size of Selected Image MB Press Play to EstimateViewing a Copied File Call Overview On or OFFQuad Display Sharpness Screen Display Setting & ModeMode Button Upgrade Firmware Networking Overview Introduction to TCP/IPSubnet Masks Pre-Installation Gateway AddressVirtual Ports Page What Type of Network Connection do you have? Connection Procedure Simple One to One ConnectionCrossover Ethernet Cable Pin outs Page Page Page Page Page Straight Through Ethernet Cable Pin outs Direct High Speed Modem ConnectionPage Router or LAN Connection Connection Procedure Page Linksys Port Forwarding Sample Screen Dynamic DNS Page Link Port Forwarding Example1 Virtual Server Select Enabled or DisabledDynamic DNS Page EverFocus Ddns server EverFocus Ddns SetupExample http//hostname.everfocusddns.com Viewing through Internet Explorer ActiveX bar at the top of your browser screen Enabling ActiveX ControlsEnable DisablePrompt 719 Page Page Search by Time SearchSearch by Event PTZ control Remote Archive Page Press Download DVRViewer button Page Page Remote Configuration Page Camera setup menu Record setup menu Alarm setup menu Page Page Schedule setup menu Control setup menu Page Interface Specifications Transmission SettingPin 3 RS-485 + Pin 6 RS-485 0x0B DATA1 = Play keycode 0x59 checksum Remote Control ProtocolCH1 Call Appendix a Remote Control Appendix B Alarm Board Configuration Alarm I/O pin assignmentSUB 25 pin female connector PR16D00400 Alarm extension DVR  The DVR will not go into record mode? Troubleshooting The DVR displays no picture?  I cannot connect to the recorder via the internet?USA Office USA N.Y. Office Europe Office Head OfficeChina Office Japan Office
Related manuals
Manual 2 pages 34.71 Kb Manual 84 pages 7.08 Kb

EDR810M, EDR410H, EDR810H, EDR410M specifications

The EverFocus EDR410M, EDR810M, and EDR410MW represent a significant leap in the domain of mobile video recorders, tailored specifically for applications in transportation and surveillance. These cutting-edge devices blend advanced technology, user-friendly interfaces, and robust construction to cater to an array of environments.

The EDR410M is a compact mobile DVR designed primarily for use in vehicles. This model supports four-channel recording, allowing for multiple cameras to be connected and monitored simultaneously. It features H.264 video compression, which ensures high-quality video at lower bit rates, optimizing storage without sacrificing clarity. The device also boasts real-time recording, enabling continuous surveillance, essential for transporting valuable goods or ensuring passenger safety.

In contrast, the EDR810M expands upon these capabilities with an impressive eight-channel recording system. This model is ideal for larger fleets or environments where comprehensive monitoring is necessary. Like the EDR410M, it utilizes H.264 compression technology and offers HDMI output for seamless connection to external displays. The EDR810M also features advanced event trigger functions, which automatically start recording in response to specific actions, such as sharp turns or sudden braking, enhancing the overall security protocol.

The EDR410MW stands out with its built-in Wi-Fi capability, providing users with the ability to access footage remotely. This feature is particularly valuable for fleet managers who need instant access to video data for review and incident analysis. All three models support a variety of storage options, including SSD and HDD, accommodating the diverse needs of modern transportation services.

Another key characteristic shared by these models is their rugged design, ensuring resilience against harsh environmental conditions. They are built to withstand vibrations and shocks, as commonly experienced in mobile applications. Furthermore, they come equipped with GPS functionality, enabling location tracking and route mapping for optimizing logistics.

Overall, the EverFocus EDR410M, EDR810M, and EDR410MW embody a blend of innovative features and robust technology that are crucial in the mobile surveillance market. These devices empower fleet managers and security personnel with the tools they need to enhance safety, accountability, and efficiency in their operations.