INSTALLATION:
A.DISASSEMBLE DASHBOARD:
1.Remove long dash trim. This is trim piece that contains trunk release and rear defroster switch.
2.Pull AM/FM radio, HVAC controls, and trunk release button.
3.Remove 7mm Hex Head Screws located above speedometer control, and below AM/FM Radio.
Note: This will ease installation of Monitor Mounting Bracket. Do not unplug HVAC controls. Lay HVAC controls gently on floor of car.
B.INSTALLING DASH MOUNT SUPPORT BRACKETS:
1.Run power and ground for monitor to factory heater control hole
2.Run large black data cable that connects monitor to CPU, to factory heater control hole.
3.Cut long dash trim panel to 22 3/8” (removed in step A.1.). Make sure cut is smooth and even and put back into place.
4.Remove (4) 7mm hex head sheet metal screws from dash panel.
5.Mount Monitor Dash Bracket using (6) #8 X 1 ½” Black sheet metal screws.
6.Mount attached clamps using (4) attached
7.Support the main part of plate w/ sheet metal screws prior to mounting the clamps. Be sure that these screws are flush to dashboard.
Note: Pull cables through bottom hole in Monitor dash bracket.
8.Position trunk release filler plate (CM93603) behind Monitor dash bracket where trunk release hole is located.
9.Push trunk release switch through hole.
Note: Make sure trunk release catches filler plate.
10.Plug in trunk release wires: On
11.Mount monitor to Monitor Mounting Plate
(6)
12.Plug in power cable and Data cable. Mount monitor to dash bracket w/ (4)